Signal Format - JVC DT-V21G11 Bedienungsanleitung

Audio Channel Selection
Select audio channels emitted from the speakers (L/R) and the AUDIO MONITOR OUT (OUT1(L)/OUT2(R)) terminals, when EMBEDDED AUDIO
signals come in to the SDI terminal and SDI input is selected.
●
You have to choose a group of selectable audio channels before the channel selection (☞ "E.AUDIO GROUP" in "AUDIO SETTING" on page 16).
●
The setting is memorized for each input (SDI 1 and SDI 2).
1
Press or button when a menu is not displayed.
The screen for audio channel selection is displayed.
●
The screen for audio channel selection automatically disappears in about 30 seconds after the previous operation.
2
Press buttons to select the left (L ch) or right (R ch).
3
Press buttons to select an audio channel.
●
Each time you press the button, the audio channel changes according to the settings of "E.AUDIO GROUP." (☞ page 16)
4
Press MENU button.
● The screen for audio channel selection disappears.
On the Information Display
The monitor displays the information below.
Configure the show/hide setting of each item in the menu. Use the T.C. button (☞ r on page 10) to configure 5 and 6.
●
●
Select the position of the information display (☞ "POSITION" in "INFORMATION" on page 21).
1 Audio level meter
● You can check the conditions of the EMBEDDED AUDIO signals when "LEVEL METER ch" is set to "LINE" or "DIVIDE."
● Not displayed when "LEVEL METER ch" is set to "OFF." (☞ "AUDIO SETTING" on page 16)

2 Signal format

●
Displayed when "STATUS DISPLAY" is set to "ON." (☞ "INFORMATION" on page 21)
●
For the contents displayed, see "Available signals" on page 29 and "On the signal format" on page 12.
3 Source name assigned in "CHARACTER SET."
● Displayed when "SOURCE ID" is set to "ON" or "AUTO."
● Displayed in large letters when "STATUS DISPLAY" is set to "OFF" or "AUTO." (☞ "INFORMATION" on page 21)
4 CRC error indication
●
Displayed when "CRC ERROR" is set to "ON." (☞ "INFORMATION" on page 21)
●
A red square is displayed when an error occurs.
5 Time code
When the input signal includes no time code, "TC – –:– –:– –:– –" is displayed (☞ r on page 10).
●
Audio channel selection screen
Selected item
EN EN
11