Control Lock - JVC DT-V21G11 Bedienungsanleitung

Setting the menu (cont.)
REMOTE SETTING
Settings for the external control.
Item
SERIAL TYPE
PARALLEL TYPE
PIN1
PIN2
PIN3
PIN4
PIN5
PIN6
PIN7
PIN8

CONTROL LOCK

Settings for disabling the buttons on the front panel.
●
The following operations are not available when "VOL.LOCK" is selected.
– VOLUME adjustment knob
– Picture adjustment knob
●
The "ALL LOCK" function disables to control the buttons on the front panel. But following operations are available.
– Turning on/off (on standby) the monitor.
– Press the button and
– Operate this product by external control.
When you perform operations other than the above, "
DVI INPUT SEL.
Settings for formats of signals input into the DVI-D (HDCP) terminal.
●
Automatically distinguishes signals when set to "AUTO." (Normally, select "AUTO")
● Select "COMPO.", "RGB" or "PC" when the picture is not displayed correctly with "AUTO."
●
DVI-D input of the monitor is compatible with HDCP.
SDI FORMAT
Setting value: AUTO, MS1YCbCr, MS2YCbCr, MS3YCbCr, MS4YCbCr, MS2 RGB, MS3 RGB, 3G-B-DS
When "AUTO" is selected, 3G SDI/HD-SDI DUAL LINK signals are automatically recognized. (Normally select "AUTO.")
● If the picture is unstable with "AUTO", select the setting value according to the input signal format.
●
"M" is displayed on the status display when a setting other than "AUTO" is selected.
20
(☞ "External Control" on pages 22)
Content
Select the input terminal used for external control by serial
communication.
Select the external control method for the MAKE/TRIGGER terminal.
Assign the control functions to the pins of the MAKE/TRIGGER terminal.
• Assign a function to each pin terminal by selecting "SET" in "PARALLEL
TYPE" mentioned above.
The functions are assigned for "PIN6" – "PIN8" and you cannot change the
assignment of these functions.
Setting value: OFF, VOL.LOCK, ALL LOCK
button to display the SET-UP MENU, and set "CONTROL LOCK" to "OFF."
Setting value: AUTO, COMPO., RGB, PC
Control lock on!" appears.
Setting value
RS232C
RS485
MAKE, TRIGGER, SET
☞ <Functions controlled by the
MAKE/TRIGGER system> on page
23.
☞ "Using the MAKE/TRIGGER
system" on page 22