Inhaltsverzeichnis
Werbung
Connection diagram for standard mode
1. Antenna jack
10.
Note:
Depending on the kind of vehicle, the function
15 cm
of 3* and 5* may be different. In this case, be
sure to connect 2* to 5* and 4* to 3*.
2. DSP switch
Switch the DSP switch
1*
3. This Product
as illustration below.
3*
2*
5*
4*
11. Connect leads of the same
color to each other.
4. IP-BUS input (Blue)
12. Cap (1*)
5. Multi-CD player
When not using this terminal,
(sold separately)
do not remove the cap.
6. IP-BUS cable
13. Yellow (3*)
14. Yellow (2*)
15. Fuse holder
Back-up
To terminal always supplied
(or accessory)
with power regardless of
ignition switch position.
18. Fuse resistor
16. Red (5*)
17. Red (4*)
Accessory
To electric terminal controlled
by ignition switch (12 V DC)
(or back-up)
ON/OFF.
19. Orange/white
18. Fuse resistor
To lighting switch terminal.
20. Black (ground)
To vehicle (metal) body.
21. ISO connector
22. Yellow/black
Note:
If you use a cellular telephone, connect it via the
In some vehicles, the ISO connector may
Audio Mute lead on the cellular telephone. If not,
be divided into two. In this case, be sure
keep the Audio Mute lead free of any connections.
to connect to both connectors.
24. Connecting cords with RCA
pin plugs (sold separately)
23 cm
7. Subwoofer output
(LOW/SUBWOOFER OUTPUT)
8. Rear output
(MID/REAR OUTPUT)
15 cm
9. Front output
(HIGH/FRONT OUTPUT)
25. Power amp
(sold separately)
26. Blue/white
To system control terminal of the
power amp (max. 300 mA 12 V DC).
15 cm
27. System remote control
28. Blue/white (7*)
To Auto-antenna relay control
terminal (max. 300 mA 12 V DC).
29. Blue/white (6*)
30.
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
31. Left
+
+
33. Front speaker
≠
≠
+
+
34. Rear speaker
≠
≠
+
+
35. Subwoofer
≠
≠
23. Speaker leads
: Front left +
White
White/black : Front left ≠
36. Perform these connections when using
: Front right +
Gray
a different amp (sold separately).
Gray/black : Front right ≠
: Rear left +
Green
Green/black : Rear left ≠
Violet
: Rear right +
Violet/black : Rear right ≠
Connection diagram for 3-way network mode
10.
Note:
25. Power amp
Depending on the kind of vehicle, the function
(sold separately)
of 3* and 5* may be different. In this case, be
sure to connect 2* to 5* and 4* to 3*.
25. Power amp
1*
(sold separately)
3*
2*
5*
4*
12. Cap (1*)
When not using this terminal,
do not remove the cap.
13. Yellow (3*)
14. Yellow (2*)
Back-up
To terminal always supplied
(or accessory)
with power regardless of
ignition switch position.
16. Red (5*)
17. Red (4*)
Accessory
To electric terminal controlled
by ignition switch (12 V DC)
(or back-up)
ON/OFF.
32. Right
33. Front speaker
19. Orange/white
To lighting switch terminal.
20. Black (ground)
To vehicle (metal) body.
34. Rear speaker
35. Subwoofer
21. ISO connector
Note:
In some vehicles, the ISO connector may
be divided into two. In this case, be sure
to connect to both connectors.
Fig. 12
Abb. 12
Afb. 12
1. Antenna jack
23 cm
37. Low range output
(LOW/SUBWOOFER OUTPUT)
15 cm
2. DSP switch
38. Middle range output
Switch the DSP switch
(MID/REAR OUTPUT)
3. This Product
15 cm
as illustration below.
39. High range output
(HIGH/FRONT OUTPUT)
11. Connect leads of the same
26. Blue/white
color to each other.
4. IP-BUS input (Blue)
To system control terminal of the
power amp (max. 300 mA 12 V DC).
15 cm
5. Multi-CD player
(sold separately)
6. IP-BUS cable
28. Blue/white (7*)
To Auto-antenna relay control
terminal (max. 300 mA 12 V DC).
15. Fuse holder
29. Blue/white (6*)
30.
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
18. Fuse resistor
18. Fuse resistor
22. Yellow/black
If you use a cellular telephone, connect it via the
40. Speaker leads
: High range left +
Audio Mute lead on the cellular telephone. If not,
White
keep the Audio Mute lead free of any connections.
White/black : High range left ≠
: High range right +
Gray
Gray/black : High range right ≠
: Middle range left +
Green
Green/black : Middle range left ≠
Violet
: Middle range right +
Violet/black : Middle range right ≠
24. Connecting cords with RCA
pin plugs (sold separately)
25. Power amp
(sold separately)
25. Power amp
(sold separately)
25. Power amp
(sold separately)
27. System remote control
31. Left
32. Right
+
+
41. High range
41. High range
speaker
speaker
≠
≠
+
+
42. Middle range
42. Middle range
speaker
speaker
≠
≠
+
+
43. Low range
43.Low range
speaker
speaker
≠
≠
36. Perform these connections when using
a different amp (sold separately).
44. External amp is required for
Fig. 13
connecting the low range speaker.
Abb. 13
Afb. 13
Werbung
Inhaltsverzeichnis
