Philips DSR3131H Benutzerhandbuch Seite 30

Issue
Usb hard drive is not
recognized
Usb hard drive is not
recognized
Few programs
Receiver turns itself on or
not immediately
Possible solution
Perhaps the current consumption of the USB hard drive is too high. Only
use USB hard drives with its own power supply. Perhaps the storage
medium is defective or not properly formatted in FAT32 format. Check the
storage media to a PC to function and format the hard drive, if necessary
on FAT32 format (Note: data loss).
The device displays incorrect program times in the EPG or the wrong time:
After switching on the receiver the data has to be read and evaluated.
Depending on the transponder this process may take some time.
Sometimes it may be necessary to terminate the EPG and call again or
switch the channel position. The device does not respond. If the device is
not in update mode fi nd, unplug the power cord, then wait a few seconds
before putting the instrument back into operation. This does not help,
reset the machine if necessary to the factory settings (Menu Software /
factory settings) .If you can operate a DECT cordless telephone
sporadically cause this interference of satellite reception. This is because
DECT operates on frequencies that are used for the transmission of the
signal from the LNB to satellite receivers. Provide problems for correct
installation of the antenna cable, particularly in view of an effective RF
shielding the line. In addition it recommends to be far away from the
satellite receiver and the antenna line to set up the DECT base station.
The antenna may be aligned to the wrong satellite position. When aligning
the antenna, it can happen that you receive one of numerous satellites,
which is transmitting on a similar frequency and the signal display on the
receiver. When switching channels then often foreign programs and very
often the note appear that no signal is received. It is often enough to turn
the antenna a few degrees to the east or west to receive the desired
channels. Make sure you have the correct list of favorites activated.
The receiver performs automatic data updates periodically and turns this
one and after the upgrade automatically again. In this way, may be
delayed in time and turning off the receiver.
30