Trouble-Shooting Guide - Philips DSR3131H Benutzerhandbuch

6 Trouble-shooting guide

Issue
Unit is not functioning
No picture
Common Problems
Device switchs itself off
Possible solution
Check if the power cord securely plugged into a power outlet.
If necessary, check whether other devices to this socket function properly.
If on the TV unit to a TV picture still OSD contents of the receiver display:
Check whether the TV is switched to the input, is connected to the receiver
(HDMI / SCART). Are displayed on the TV only OSD contents of the
receiver, but no TV image of the receiver: If you are self-mounted antenna
connector Ensure that the shield (poultry genuine and film) in contact with
the connector, but does not touch the inner conductor. If necessary, try a
different antenna line. Check the antenna settings: For the ASTRA
satellites should be set as a rule "Digital". Do not use a universal LNB, it
must be the values 9750 MHz and 10600 MHz for the lower and upper LNB
frequency set normally. For troubleshooting, you should connect the
LNB and the receiver directly and remove the switch and splitter. For
copyright reasons there is no image output via the SCART socket, if the
currently selected HD + program will be sent with a copy. Turn in this case,
if necessary, to the identical program in SD dissolution. With SCR
Einkabelanlagen EN 50494 each participant must use a different IF
channel and another IF frequency. This should centrally coordinated and
the data is recorded at all doses antenna / antenna lines. Participants with
a long antenna cable should get preference assigned to the low
frequencies. In the new installation of another receiver every receiver
involved should be switched on if possible. In case of faults, the above
points must be examined. Changed settings will not take effect until the
next time the receiver.
There may be a software upgrade via satellite, which fixes an issue: Turn
the receiver off and unplug the power cord from the wall outlet. After a
short wait time you connect the receiver to the power grid, so that the
receiver can perform a possibly via the Astra satellite at 19.2 ° East
existing update. Note that the self-running update can take more than 60
minutes.
This is not an error, but the auto power off (see section 4.10).
29