Philips DSR3131H Benutzerhandbuch Seite 22

5.2.2 Antenna config
LNB Type
Can switch C Band/Extended C Band/Universal/Ku Band /User, with different LNB Type, frequency will
follow different.
22 KHz
The 22kHz signal is used to switch a universal LNB ("Off" = Low Band, "On" = high band). Have you
selected as LNB type "digital" and set "Automatic", the automatic switchover. If you do not have a
commercial LNB, you have to make at this point the setting manually.
DiSEqC (DiSEqC 1.0 or DiSEqC 1.1)
If "DiSEqC" is activated, the setting including the desired port 1 - 16 are elected.
Tone Burst
If "Tone Burst" is activated, the setting Including the Desired Tone Burst "A" or "B" are chosen. Enable
if you have a Tone Burst switch to receive up to two satellites mounted on the antenna system, the "Tone
Burst" feature only.
Positioner
Here you can select whether the rotor control the receiver deactivated ("Off") or activated ("DiSEqC
1.2" or "USALS") to be. Press the blue button to adjust the engine settings.
DiSEqC 1.2 Motor type setting
Moving Type
Can switch User/Installer/GOTO X/Advanced. If
switch to Advanced, "Recalculate" and "Reset
Position" is enable.
Go to X
For easy access to other satellites, you can select
saved positions and then drive here directly.
Drive E/W
Control with 3 / 4 the antenna to the west or east.
Observe always the signal indicators. Should you
not receive a signal level in the search, choose
"Select Transponder" another transponder.
22