Sony LT20A-101 Anleitung Seite 101

Item Model
LT20A-101
Peak hold function
Maximum, minimum, and peak-to-peak values. Measuring started by the start input of the I/O connector;
update stop by pause input.
Input resolution
Display resolution
Direction
Reference point
Function use enabled/disabled can be selected (if use is enabled, the unit enters reference point signal input
function
Maximum response frequency
Addition and subtraction function
Alarm
Speed over or measuring unit cable disconnected (Displayed on LCD or the I/O connector's comparator
outputs are all "H" (OFF).)
Data storage
Temperature
Power consumption *5
Mass
Approx. 200 g
Power voltage
Compatible measuring unit
∗ ∗ ∗ ∗ ∗ 3: RS-232C (8 pin mini-DIN connector)
Reset, preset value setting/recall, peak-hold start, peak-hold pause,
current value hold, reference point reset, reference point offset value
read, software version read, comparator value setting, current value/
maximum value/minimum value/peak-to-peak measuring mode
selection and output, key lock and release.
LT20A / LT30 Series
101B
— —
0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm selectable
0.0005 mm, 0.001 mm, 0.005 mm, 0.01 mm (0.00002", 0.00005", 0.0002", 0.0005") selectable
wait status at the same time as power-on).
—
BCD alarm
—
terminal "H" (OFF)
Resolution, direction, comparator value, preset value, modes, etc.
— BCD sign, etc
Operating temperature: 0 to 40°C Storage temperature: –10 to 50°C
4 W 5 W
Approx. 230 g
Power input connector (3 pins) : DC10.8 to 26.4 V.
101C 201
RS-232C can set
—
or start.
Can be switched
20 MHz (A/B phase difference)
A+B, A–B, B–A can be set with the direction setting.
See P41 —
Data signalling rate, etc. —
4 W 6 W
Approx. 220 g Approx. 210 g
DG, DL series
∗ ∗ ∗ ∗ ∗ 4: RS-TRG pin
Trigger input for RS-232C data output
∗ ∗ ∗ ∗ ∗ 5: With measuring unit connected.
201B 201C
RS-232C can set
—
or start.
BCD alarm
See P41
terminal "H" (OFF)
BCD sign, etc Data signalling rate, etc.
8 W 6 W
Approx. 270 g Approx. 230 g
43
(E)