Optipoint Isdn Adapter - Siemens optiPoint key module Montageanleitung

optiPoint ISDN Adapter

Safety notes
The optiPoint telephones and adapters comply with the stipulated conformity
and safety regulations (CE).
• Avoid exposing the equipment to direct sunlight or other sources of heat.
• Protect the equipment from moisture and liquids.
• Never insert objects into openings in the equipment.
Applications
The ISDN adapter can be connected to the following telephones:
optiPoint 600 office, optiPoint 500 advance/standard/basic.
The ISDN adapter is used to provide the ISDN S
The S terminals must have a separate power supply.
0
The port is located on the back of the adapter.
Only one ISDN adapter can be used with each U
Package Contents
• 1 optiPoint ISDN adapter
Installation
For installation, see fold-out page 3 (Pos.
1. Disconnect the subscriber line from the optiPoint telephone.
2. Place the telephone
3. Insert the adapter
telephone by sliding the two tabs
4. Gently press the adapter in the direction of the arrow
ed into place.
5. You can connect up to two ISDN terminals on an S
150 meters long and has two 100
er. However, you cannot operate both ISDN terminals simultaneously, since
only one B-channel is available.
6. Reconnect the subscriber line to the optiPoint telephone.
The optiPoint telephone and the adapter are ready for operation.
to
on a soft surface with the keypad facing down.
into one of the two adapter bays on the bottom of the
into the two slots
Ω
terminating resistors, to the ISDN adapt-
optiPoint ISDN Adapter
basic access for S
0 0
subscriber line.
P0/E
).
on the telephone.
until it is fully insert-
bus, which can be up to
0
terminals.
39