Please Observe The Following - WolfVision VZ-C32 Bedienungsanleitung

Precautions
Dangerous voltage inside

Please observe the following:

CAUTION! INSTALLATION AND SERVICING OF THE VISUALIZER MUST BE
PERFORMED BY QUALIFIED SERVICE/INSTALLATION PERSONNEL FOLLOWING
THE MANUFACTURER'S INSTALLATION INSTRUCTIONS AND IN COMPLIANCE
WITH THE NATIONAL ELECTRIC CODE, ALL LOCAL BUILDING AND SAFETY
CODES AND ALL OTHER APPLICABLE CODE PROVISIONS OR REGULATIONS.
PINCH POINT! MOVING FOLDING MECHANISM CAN CRUSH FINGERS.
KEEP HANDS CLEAR. LOCKOUT BEFORE SERVICING.
USE THIS UNIT ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE
LABEL !
DO NOT EXPOSE THE UNIT TO HEAT OR MOISTURE !
PROTECT THE UNIT FROM EXCESSIVE SHOCKS !
Make sure that sufficient air circulation for cooling the unit is possible (ventilation
slots on the left and right side of the unit)!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit
from mains immediately and contact your Visualizer dealer!
Do not use a damaged power cord.
This may cause short circuits or electrical shocks!
To prevent danger, do not modify the unit or operate without the cover panel firmly
in place!
Do not expose the unit to water, metallic objects or any flammable material.
Avoid installing the unit in locations exposed to strong magnetic fields or electrical
currents.
Avoid installing the unit in environments where there is radiation.
This could cause monitor image distortion or damage to the CCD camera.
Do not pull the plug from the power socket with wet hands!
If the unit is not used for a long time, disconnect it from mains!
Precautions for laser pointer:
LASER RADIATION - DO NOT
STARE INTO BEAM
650nm, P<1mW
CLASS II LASER PRODUCT
WARNING!
Risk of electric shock
AVOID EXPOSURE
Laser radiation is emitted
from this aperture.
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
OUTPUT POWER <1mW
WAVELENGTH 650nm
EN 60825-1 March 1997
1
ENGLISH
Laser information
-
FDA accession number:
9912688-00
This device complies with
21 CFR 1040.10 and 1040.11