Maintenance; Firmware Upgrades - WolfVision VZ-C32 Bedienungsanleitung

Automatic Lamp Changer
The Ceiling Visualizer is fitted with an automatic lamp changer.
If one lamp fails, there is no need to replace it immediately, as the automatic lamp changer
automatically switches to the second (spare) lamp. When the unit changes lamps there is
an on-screen message saying: "Changing lamp".
When switching on the unit the Visualizer checks if both lamps are working. If one lamp fails
there will be an on screen message for a couple of seconds displaying "Lamp x blown".
This prevents a user from forgetting to change a defective lamp.
Thermostat
If the unit gets too hot (improper ventilation or air extraction) a built in thermostat will switch
off the light of the Visualizer. Verify that proper ventilation and air extraction is available and
allow the unit to cool.
Dimensions
Closed:
18 95
400
452
90 92
All measurements in millimeters (for inch see list)

MAINTENANCE

Firmware Upgrades

The software (firmware) of your Visualizer (including the o
upgraded to the latest version. The firmware update can be done via USB, Ethernet (LAN)
or RS232.
Firmware update files can be downloaded for free at www.wolfvision.com/support.
Updates via USB can be made with the WolfVision USB Software, updates via
Ethernet/LAN require the WolfVision Ethernet Software and updates via RS232 can be
made with WolfVision's Firmware Update Utility. All three programs can also be found on
our homepage.
For RS232 connection, use a crossed serial RS232 cable (Nullmodem-cable).
Cooling
Air Outlet
IMPORTANT NOTE:
DO NOT BLOCK
COOLING AIR
INLET AND
OUTLET!
Cooling
Air Inlet
Ceiling mount
n-screen HELP
16
240
Open:
160
135
160
) can easily be
mm
Inch
12 0.47
18 0.71
40 1.57
58,1 2.29
60 2.36
70 2.76
72 2.83
80 3.15
90 3.54
92 3.62
95 3.74
125,5 4.94
135 5.31
144 5.67
160 6.3
206 8.11
240 9.45
285 11.22
352 13.86
390 15.35
400 15.75
452 17.8
528 20.79