WolfVision VZ-C32 Bedienungsanleitung Seite 19

Exchanging Lamps
Before changing the lamp allow it to cool or use a cloth to avoid burning fingers!
When inserting a new lamp into the socket use a cloth to prevent fingerprints on the lamp!
1. Turn the unit off (#12) and disconnect the power cord (#15)!
2. Press the release button and swing the unit downwards. (see figure 1 and figure 2)
3. Release the quick lock by turning and lift up the lid. (see figure 2)
4. CAUTION: LAMP CAN BE HOT!
Change the lamp (or both lamps) (see figure 3)
5. To swing the unit up, release the security lock mechanism, by pulling and turning
counterclockwise. (see figure 2)
Lamp type: Halogen long life lamp 24V/150W at 300 h average burning life.
WolfVision part no.: 4643
release button
figure 1
Exchanging Fuses
Disconnect the power cord (#15) before changing the fuses!
The fuses (#14) are situated behind a small lid at the power socket.
It can easily be opened with a small screwdriver etc.
Remove the socket, exchange the fuse(s) carefully,
and put back the socket the right way round into the socket holder.
The type of fuse is: T 3,15A. Do not use any other type !
Change the fuses for new ones and switch the unit on.
If the fuse fails again contact your Visualizer dealer!
CAUTION!
Pinch Point!
figure 3
security lock
mechanism
quick
lock
18
LOCKED
UNLOCKED
figure 2
pull
and
turn
to
unlock