Please Observe The Following - WolfVision VZ-9plus 3 Bedienungsanleitung

Precautions
Dangerous voltage inside

Please observe the following:

Use this Visualizer only with the correct voltage as shown on the type label !
Do not expose the Visualizer to heat or moisture !
Protect the Visualizer from excessive shocks !
Make sure that sufficient air circulation for cooling the Visualizer is possible (ventilation slots on
the lamp housing)!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the Visualizer from
mains immediately and contact your Visualizer dealer!
Do not use a damaged power supply / power cord. This may cause short circuits or electrical
shocks!
To prevent danger, do not modify the Visualizer or operate without the cover panel firmly in place!
Do not expose the Visualizer to water, metallic objects or any flammable material.
Avoid installing the Visualizer in locations exposed to strong magnetic fields or electrical
currents.
Avoid installing the Visualizer in environments where there is radiation. This could cause
monitor image distortion or damage to the CCD camera.
Do not pull the plug from the power socket with wet hands!
If the Visualizer is not used for a long time, disconnect it from mains!
The external power supply has to be approved by CSA or UL in accordance to CSA 22.2-60950 or
UL 1950. The outputs have to be LPS (limited power source) rated!
Precautions for laser pointer and laser center marker:
Laser light - Do not stare into beam!
Do not modify the laser! Do not view the laser beam with optical instruments!
Information for laser pointer
FDA accession number: 9912688-00
This device complies with 21 CFR 1040.10 and 1040.11
WARNING!
Risk of electric shock
Technical data:
λ = 635 - 680nm
P < 1mW
Θ 2mrad
This label will be found on the
underneath of the remote
control.
The laser beam exits the
remote control through the
smaller (left) opening on
the front.
Information for synchronized laser markers
1
ENGLISH
Technical data:
λ = 635nm
P < 1mW
cw/cp = 2 - 28ms
This label will be
found on the camera
arm .
The laser beam of the
centre marker exits the
unit through the camera
lens.