Road Test - Waeco MS-400 Montageanleitung Und Bedienungsanleitung

Road test

Start your vehicle and turn the cruise control on using the command module ON/OFF
button.
While driving at around 40 km/h (25 MPH) press and release the SET/ACC button and
you should feel the cruise control take over. The lowest speed that your cruise control
will operate is the minimum engage speed, this should be around 40 km/h (25 MPH).
The cruise control should now engage smoothly and maintain a stable vehicle speed.
Sensitivity adjustments
If the cruise control does not engage smoothly or if the cruise control gains or looses
speed while cruising you can make adjustments to the sensitivity settings of the cruise
control. If the cruise control engages too quickly, you can decrease the INIT count. If the
cruise control engages to slow, you can increase the INIT count. When the cruise control
is engaged and gains speed, acts erratically or seems too responsive, you can decrease
the GAIN factor. If the cruise control loses speed or seems to be sluggish in response you
can increase the GAIN factor.
All the sensitivity settings can be adjusted in SET-UP mode, please refer to the flowchart
(see page 63).
Trouble shooting guide
This section of the manual includes a list of potential problems and a list of recommended
checks to perform to solve these problems.
The LED on the electronic module does not light when the command module
buttons are pressed.
Check the 8-pin command module connector from the electronic module and make
certain that it is connected correctly to the command module. Check the colour code on
the command module connector and make certain that you have inserted the terminals
into the command module correctly. If these are inserted correctly then check the main
electronic module power supply and earth connection. The orange wire should have the
battery voltage (+12 V) when the ignition is switched on and the green wire should have
earth at all times.
58