Connecting The High-Pressure Hose - ACO Lipumax-P Gebrauchsanleitung

Grease separators Lipumax-P -B, -D, -DM, -DA
Installation
Use the carrier pipe to place the raised
Î
bracket part on the opposite dogging
element and push down above the
threaded pin.
Screw the star handle onto the threaded
Î
pin and tighten hand-tight.
Bracket is completely installed.
Place the connection cable of the HP
Î
head in the supply pipe.

3.3.6 Connecting the high-pressure hose

IMPORTANT After the work:
Installing the bracket with HP head,
■
Place the connection cable of the HP head in the supply pipe,
■
on-site pipes and cables – connect supply pipe".
Place the high-pressure hose in the supply pipe,
■
and cables – connect supply pipe".
Connect the high-pressure hose to the HP head
■
the opening of the supply pipe in the housing must be sealed with the cable gland,
Chap. 3.3.7 „Install cable gland".
The high-pressure hose and cable gland are enclosed as loose items with the as-delivered
separator.
IMPORTANT Fasten excess length of the
high-pressure hose in loops in the raising
system.
Connect the high-pressure hose to the
Î
HP head.
100/ 144
11
Chap. 3.3.5
Chap. 3.3.4 „Connect on-site pipes
Chap. 3.3.4 „Connect