Topcom butler 4056C Bedienungsanleitung Seite 18

Butler 4056/4056C
• Press the Up or Down key
• Press the Programming key
• 'OLD CODE' appears on the display.
• Enter the old PIN code. Use the number keys.
• Press the Programming key
• 'NEW CODE' appears on the display.
• Enter the new PIN code in. Use the number keys.
• Press the Programming key
• 'AGAIN' appears on the display.
• Enter the new PIN code again. Use the number keys.
• Press the Programming key
• You hear a confirmation tone. The new PIN code has been set.
Caution : Do not forget your personal PIN code. If you do, you have to restore the
default settings (reset – see section 4.30).
4.23 SUBSCRIBING A HANDSET TO A B24XX, 28XX, 29XX, 32XX, 40XX
In order to be able to make and receive telephone calls, a new handset has to be subscribed
to the base unit. You can subscribe 5 handsets to one base unit. By default, each handset is
subscribed as handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if: !!!
• the handset subscription has been removed from the base unit (e.g. for reinitialisation)
• you want to subscribe a different handset to this base unit.
The underlined procedure is only applicable to a B40XX handset and base unit!!
Keep the Paging key
indicator on the base unit begins to blink rapidly. The Line/Charge indicator
blink rapidly for one minute. During this minute, the base unit is in subscribing mode and you
must do the following to subscribe the handset:
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'BASE _' appears on the display.
• Enter a number of the base unit you would like to subscribe the handset to (1-4).
Use the number keypad.
Note: Each handset can be subscribed to 4 different DECT base units. Each base
unit is assigned a number from 1 to 4 in the handset. When you subscribe a new
handset, you can assign a base unit number. It is best to use '1' .
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a
signal sounds when the handset has found the base unit.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit in (default PIN code is '0000'). Use the number
keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
18
repeatedly until 'PIN CODE' appears on the display.
.
.
.
.
on the base unit pressed for 10 seconds until The Line/Charge
.
repeatedly until 'BASE SUB' appears on the display.
.
appears on the display.
.
.
will
Butler 4056/4056C