Carrying Out Measurements - VOLTCRAFT 304 Bedienungsanleitung

In order to make communication possible between the thermometer
and an IBM-compatible PC, at first the prerequisite conditions have
to be established:
A connection between PC and thermometer and the installation of
the software.
Note!
The interface circuit as well as the software are optionally avai-
lable as packages.
c) Connecting an Adapter
And finally jack 9V DC. Here an adapter with the following output
data can be connected: 9V DC voltage, if possible stabilised, with
an output current of at least 100mA, an external connector diameter
of 1.35mm and an internal connector diameter of 1.35mm. The
polarity: minus "-" inside, plus "+" outside.
D Working Position
Always operate the Digital 4-Channel Thermometer 304 in a position
that you can read the LCD display or that the digital display points
to the top resp.
Via the tripod thread in the bottom part of the housing the measu-
ring device can be fixed to a tripod.

Carrying Out Measurements

The temperature measuring range of the digital thermometer
extends from – 200°C to +1370°C for K-type sensors. The tempera-
ture range of the enclosed K-type sensors extends from – 50°C to a
maximum! of +200°C. Do not measure temperatures above +200°C
(= 392°F) with the sensors enclosed.
31