Waeco MagicSafe MS-670 Bedienungsanleitung Seite 44

_MS-670.book Seite 44 Donnerstag, 8. Mai 2008 4:55 16
Connecting the electrical power to MagicSafe
Brown (P9)
➤ Connect this cable to the blue alarm siren cable.
Green (P11) and green/yellow (P12)
➤ This cable can interrupt any electrical circuit (e. g. fuel pump, starter etc.).
The output can be charged with a maximum of 8 A.
Connecting the alarm siren
➤ Guide this cable through the splash-protection wall in the engine
compartment.
➤ Connect the red cable of the alarm siren to a cable with a permanent
+12 V charge (terminal +30).
➤ Connect the blue cable of the alarm siren to the brown cable (terminal P9)
of the connection cable.
➤ Connect the grey cable to the engine bonnet contact switch (3).
➤ Connect the black cable to earth (terminal 31).
Connecting the key holder
➤ Insert the red two-pin plug (8) of the connection cable in the red socket (8)
of the key holder.
➤ Insert the white two-pin plug (9) of the connection cable in the white
socket (9) of the key holder.
Violet (P20)
➤ Connect this cable to a connection which is switched by the ignition
(terminal 15).
Connecting the ultrasonic module
➤ Insert the white three-pin plug (11) in the connection of the ultrasonic
module.
44
MagicSafe MS670