Waeco MagicSafe MS-670 Bedienungsanleitung Seite 48

_MS-670.book Seite 48 Donnerstag, 8. Mai 2008 4:55 16
Programming MagicSafe
Activating the next function
➤ Switch the ignition off and on again.
✓ The next function is activated.
➤ Modify the value as described above or switch the ignition off and on
again to activate the next function.
➤ Once you have called up all functions in sequence, switch the ignition off
and on again to confirm the entered values.
✓ The alarm system indicates the leaving of the programming mode and the
storing of the entered values by having the LED on the control device
flash three times and the alarm siren emit three acoustic signals.
8.3 Programming a new electronic key
MagicSafe can be operated with up to four electronic keys. If you want to
program a fifth key, the first will be deleted from the memory.
I
Note:
To program a new electronic key, the engine bonnet must be open.
When the signal "Engine bonnet up" is available via the CAN bus,
the grey cable must be connected to earth.
Proceed as follows to program a new electronic key:
➤ Deactivate the alarm.
➤ Switch the ignition on and off.
➤ Switch the ignition on and off again two more times within 4 seconds.
➤ Switch on the ignition and leave it on.
✓ The alarm siren emits three an acoustic signals, and the LED on the
control device flashes once.
➤ Insert the new electronic key in the key holder.
✓ The electronic key is automatically programmed.
✓ The LED flashes once when the programming is completed.
➤ Repeat the programming steps for each new E-key to be programmed.
➤ Switch the ignition off to exit the programming function.
48
MagicSafe MS670