Waeco MagicSafe MS-670 Bedienungsanleitung Seite 50

_MS-670.book Seite 50 Donnerstag, 8. Mai 2008 4:55 16
Using MagicSafe
I
Note
If want to immediately reactivate the interior monitoring, switch the
ignition on and off again.
➤ Close the vehicle with your remote control.
✓ The alarm siren emits two brief confirmation signals.
✓ The vehicle emits optical signals according to the factory settings.
9.2 Deactivating MagicSafe
To deactivate the alarm system manually, proceed as follows:
➤ Open the vehicle with your remote control.
✓ The alarm siren emits a long confirmation signal.
✓ The vehicle emits optical signals according to the factory settings.
I
Note
If an alarm was triggered, the alarm siren emits a brief acoustic
signal (see chapter "Sorting the alarm memory" on page 50).
Sorting the alarm memory
MagicSafe stores triggered alarms. If you hear a short acoustic signal during
deactivation, MagicSafe has stored an alarm. You can sort the alarm
memory and specify the reason for the alarm.
Proceed as follows:
➤ Switch on the ignition and observe the LED on the key holder.
50
MagicSafe MS670