Connecting The Receiver To The Mixing Console/Amplifier; Analog Outputs; Digital Output: Dante - AKG DMS800 Bedienungsanleitung

commissioning
XLR output
Dante™
DMS800 MANUAL
6.4

Connecting the receiver to the mixing console/amplifier

The DSR800 receiver has the following outputs
•

Analog outputs

• Digital outputs
6.4.1 Analog outputs
Both analog XLR outputs (17, 20) and both analog 6.3 mm jack outputs (18,
21) can be connected at any time. The output level can be set accordingly in
the AUDIO menu.
To connect the analog outputs, proceed as follows:
Step Description
1 BALANCED socket (XLR) to microphone input: Move the out‑
put level switch to the "‑30 dB" position
2 BALANCED socket (XLR) on line input: Move the output level
switch to the "0 dB" position
3 Connect the UNBALANCED socket (6.3 mm jack) to unbal‑
anced microphone or line input to the 6.3 mm jack socket
6.4.2

Digital output: Dante™

The Dante™ technology
developed by Audinate that can mean up to 256 channels via standard IP‑
based components, such as Ethernet cables.
The Dante™ interface of the DSR800 has a data transfer speed of
100 Mbit/s.
The Dante™ Controller Software can be used to configure and manage all
devices compatible with the Dante™ network.
The Dante™ Controller Software can be downloaded free of charge from
www.audinate.com.
The Dante™ Controller Software automatically connects to the Dante™
network in the default setting.
2 Dante™ is a trademark of Audinate Pty Ltd.
represents a digital audio network technology
2
79