Meter-Feet Changeover („M" / „Ft"); Synchronisation On The Second Curtain (Rear); Shooting Format Adjustment (S.zoom) - Metz MECABLITZ 50 AF-1 digital Olympus Bedienungsanleitung

9.7 Meter-feet changeover („m" / „ft")
The maximum flash range indicated by the flash unit's display can either be
shown in metres or feet.
Setting procedure
• Press the button combination „Select" until the only the distance dimension
„m" or „ft" flashes. Apply the setting desired with the buttons + and —.
- When „m" is displayed, the distance display is in metres.
- When „ft" is displayed, the distance display is in feet.
The setting takes effect immediately. After about five seconds, the display stops
flashing and the setting is saved automatically.

9.8 Synchronisation on the second curtain (REAR)

Several cameras feature second curtain synchronisation (see 11.3).
Depending on its operating mode, the camera sets shutter speeds slower than its
sync speed.
On some cameras the REAR function is not possible in certain operating modes
(e.g., certain vari- or subject programs, or with red eye reduction). In these
cases, the REAR mode cannot be selected and/or is automatically cancelled or
ignored (see camera's operating instructions).
9.9 Shooting format adjustment (S Zoom)
If so desired, the display for the position of the main reflector can be adjusted
with the zoom size function to the Four Thirds System. To ensure complete illumi-
nation, the main reflector is always operated one level "more wide-angled",
e.g. camera lens 14 mm, mecablitz 12 mm.
Setting procedure
• actuate the shutter release in order to
transfer data from the flash unit to the
camera.
• repeatedly press button combination „Select" until
„Zoom" appears in the display and „S" flashes.
• the required settings can be applied using
the + and — buttons.
– When "S On" is displayed, the
Zoom Size function is activated.
The display of the main reflector position
is shown in the FourThirds format.
– If "S Off" is displayed, the
Zoom Size function is deactivated.
The display of the main reflector position is shown in small picture format.
The setting takes effect immediately.
After about 5 seconds the display stops flashing and the setting is saved auto-
matically. „S" is shown in the display following activation of the Zoom-Size
function.
S
OFF
S
On
On
S
97