External Power / Battery Power Operation; Inserting The Batteries - Silvercrest SWDR 500 A1 - IAN 282353 Bedienungsanleitung

SilverCrest SWDR 500 A1

External power / battery power operation

When disconnecting the multi-band tuner (A) from the power supply, different
settings (time and alarm time) are lost. To avoid this, insert batteries before
disconnecting the device from the mains. This guarantees that the mentioned
settings are preserved.
Any stored stations are preserved even if there are no batteries inserted when
disconnecting the device from the mains.

Inserting the batteries

Open the battery compartment cover (19) on the back panel of the device by
sliding it towards the bottom and remove it. Insert the batteries with the correct
polarity (+ and -), as shown in the following figure. The correct polarity is
labelled on the batteries and inside the battery compartment. Re-insert the
cover of the battery compartment (19) and slide it upwards until it locks in
place.
If the display (6) indicates a low battery level (38), the batteries are almost
empty. When this happens, replace the batteries with new batteries of the
same type.
18 - English