Setup; Connection - Conrad tu 1000 Bedienungsanleitung

Setup

When selecting the installation site, consider the room conditions, meaning the location of the next outlet, etc. Also
prevent direct sunlight, vibrations, dust, heat, cold and dampness. Keep the appliance away from strong transformers
or motors.
Operate the device only on a stable, level surface. There must be enough space around the
system for air circulation to permit dissipation of the generated heat. Therefore, only place the
device on a level surface and not on carpets, etc. Do not cover up the ventilation slots in the
casing.
If you do not heed these instructions, the device may be damaged.
Do not drill extra holes or screw any extra screws for mounting purposes into the case. This will
damage the device.
Make sure you position the appliance in a safe and stabile place, away from objects that might
might fall on it, thereby avoiding unwanted accidents.

Because of the variety of used lacquers and polishes for furniture, the device base might leave residues
on furniture due to a chemical reaction. That's why do not place the device without appropriate
protection on the valuable furniture surfaces.

Connection

Make sure before connection that the cables are disconnected from the mains. Disconnect all
other devices from the mains which are also to be connected.

Make sure that the cables are connected to the right side, that is, left to left and right to right.
23