Connections; Connecting To Line Output (Pin Jack) Terminals Of The Amplifier - Yamaha YST-SW1500 Bedienungsanleitung

Caution: Plug in the subwoofer and other audio/video components after all connections are
completed.
● All connections must be correct, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Also refer to the owner's
manual for each of your components.
● The subwoofer can be connected to either the line output (pin jack) terminals or the speaker output terminals of the amplifier.
Choose one of the ways shown in this section that is more suitable for your audio system. Also, refer to the owner's manual
of your component to be connected to the subwoofer.
Basically, connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. (Refer to pages 4 and 5 for details.)
If your amplifier does not have any line output terminal, connect the subwoofer to the speaker output terminals of the
amplifier. (Refer to pages 6 and 7 for details.)

Connecting to line output (pin jack) terminals of the amplifier

Connect the main speakers to the speaker output terminals of the amplifier.
● To connect with a YAMAHA DSP amplifier (or AV
receiver), connect the SUBWOOFER (or LOW PASS etc.)
terminal on the rear of the DSP amplifier (or AV receiver)
to the L/MONO INPUT2 terminal of the subwoofer.
Using one subwoofer
Right main speaker
Subwoofer
REMOTE
HIGH
OUTPUT INPUT
Amplifier
4
E-

CONNECTIONS

LFE
H.P.F.OUTPUT NORMAL
AUTO H.P.F.OUTPUT LFE NORMAL OUTPUT
STANDBY /MONO TO SPEAKERS
OFF 80Hz 100Hz
LOW
/MONO
GND INPUT INPUT
3 2
FROM AMPLIFIER
INPUT
1
80Hz 100Hz
POWER
ON
OFF
AC IN
GND INPUT INPUT
3
● When connecting the subwoofer to the SPLIT
SUBWOOFER terminals on the rear of the DSP amplifier,
be sure to connect the L/MONO INPUT2 terminal to the
"L" side and the R INPUT2 terminal to the "R" side of the
SPLIT SUBWOOFER terminals.
OUTPUT
TO SPEAKERS
2
FROM AMPLIFIER
INPUT
1
SPLIT SUBWOOFER
SUBWOOFER
(LOW PASS)
Left main speaker
Mono pin cable
(not included)
Audio pin cable
(not included)