Connecting To The Input1/Output Terminals Of The Subwoofer; How To Connect - Yamaha YST-SW1500 Bedienungsanleitung

Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
Right main speaker
LFE
H.P.F.OUTPUT NORMAL
/MONO
80Hz 100Hz
GND INPUT INPUT
Right
3
subwoofer
REMOTE AUTO H.P.F.OUTPUT LFE NORMAL OUTPUT
STANDBY /MONO TO SPEAKERS
HIGH OFF 80Hz 100Hz
OUTPUT INPUT LOW
GND INPUT INPUT
3 2
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
AC IN

Connecting to the INPUT1/OUTPUT terminals of the subwoofer

For connections, keep the speaker cables as short as
possible. Do not bundle or roll up the excess part of the
cables. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker
cables are observed and set correctly. If these cables are
reversed, the sound will be unnatural and lack bass.

How to Connect:

Red: positive (+)
Black: negative (–)
2
1
3
OUTPUT
H.P.F.OUTPUT
TO SPEAKERS
80Hz 100Hz
GND
2
FROM AMPLIFIER
INPUT
1
Speaker output terminals
1 Loosen the knob.
2 Insert the bare wire.
[Remove approx.
10 mm (3/8")
insulation from the
speaker wires.]
3 Tighten the knob and
secure the wire.
LFE OUTPUT
NORMAL
TO SPEAKERS
/MONO
INPUT INPUT
3 2
FROM AMPLIFIER
INPUT
1
Caution
Do not let the bare speaker wires touch each other as
this could damage the subwoofer or the amplifier, or
both of them.
<
U.S.A., Canada, Australia and Korean models only
Banana Plug connections are also possible.
2
1Tighten the terminal knob.
2Simply insert the Banana Plug connector into the
terminal.
Left main speaker
Left
subwoofer
REMOTE AUTO H.P.F.OUTPUT LFE NORMAL OUTPUT
STANDBY /MONO TO SPEAKERS
HIGH OFF 80Hz 100Hz
OUTPUT INPUT LOW
GND INPUT INPUT
3 2
FROM AMPLIFIER
INPUT
1
Amplifier
1
POWER
ON
OFF
AC IN
>
7
E-