Connecting An External Playback Device; Connecting Headphones - Silvercrest SRBN 5 A1 - IAN 271913 Bedienungsanleitung

Connecting an external playback device

You can connect a wide variety of playback devices to this device, for example
MP3 or CD players. To connect external playback devices, you will need an
audio cable (not included). One end of the cable must have a 3.5 mm jack plug
to connect to the AUX IN socket
cable will depend on the audio output of the external device.
CAUTION!
► Switch off all devices before connecting them with each other and follow
the operating instructions of the devices you want to connect.
♦ Connect the line-out connector of the external playback device (e.g. headphone
socket) via a 3.5 mm jack cable to the AUX IN socket
device.
♦ Move the operating mode selector switch
♦ Switch on the device and set the desired volume. The frequency scale
up green.
♦ Switch on the connected playback device and start playback.
♦ Turn off both devices before you disconnect them from each other.
NOTE
► Note that while in AUX mode, you can also set the volume via the external
playback device.
► If the playback sounds distorted, reduce the volume on the external play-
back device.

Connecting headphones

CAUTION!
♦ Use the volume control
♦ Plug the jack plug of the headphones or earphones into the headphone socket
( )
speaker
♦ Set the desired volume.
SRBN 5 A1
Listening to music with headphones or earphones for
long periods and at high volume levels can lead to
hearing damage!
to set the volume level to the lowest level.
on the device. Sound is now played back via the headphones and the
is muted.
. The type of plug on the other end of the
on the rear of the
into the AUX position.
lights
GB │ IE │ 23 ■