Troubleshooting; Fault Causes And Rectification - Silvercrest SRBN 5 A1 - IAN 271913 Bedienungsanleitung

Troubleshooting

This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.
Fault causes and rectification
The following table will help you to identify and rectify minor malfunctions:
Faults
Device does not
switch on.
No sound.
Interference
with the radio
reception.
The Blue-
connec-
tooth ®
tion cannot be
established.
Playback sounds
distorted in AUX
mode.
NOTE
► If you cannot solve the problem with the above-mentioned solutions, please
contact the Service Hotline (see chapter entitled Service).
■ 24 │ GB │ IE
Possible cause
The plug is not connected.
The mains power socket is not
supplying power.
The main switch is set to the OFF
position.
The volume on the device or the
playback device is set to minimum.
Playback has not been started on
the playback device.
The station is not properly tuned
in.
The reception is weak.
Possibly, not all of the Bluetooth
devices are compatible.
transmission is
®
Bluetooth
not activated on your playback
device.
The playback device is not paired
with the device.
The distance between the device
and the playback device is too
great.
The volume is set too high on the
external playback device.
Remedy
Insert the power plug into the
socket.
Check the house mains fuse.
Set the main switch to the ON
position.
Increase the volume on the device
or on the playback device.
Start playback on the playback
device.
Use the TUNING dial to tune the
desired radio station.
Try to improve reception by
realigning the telescopic aerial.
Check the settings on your
®
device.
®
Bluetooth
Switch on Bluetooth
sion on your playback device.
Please refer to its operating
instructions for more information.
Repeat the pairing process (see
section Bluetooth
Ensure that the device is no more
than 10 metres away from the
playback device.
Reduce the volume on the external
playback device.
transmis-
®
mode).
®
SRBN 5 A1