GRAUPNER TERRY S Bauanleitung Seite 26

Fit the steel pushrods (7) and (8) in the snake outers, connect them to the servo
output arms (24) and secure the arms with the output screws. Glue the snake outer
sleeves (5) and (6) to the sides of the spruce reinforcement (2).
Hold the elevator at neutral, carefully mark the point where the elevator pushrod
crosses the elevator horn, and bend the end of the rod at right-angles at the marked
point.
Repeat the procedure with the rudder pushrod. Cut off the excess rod material using
a pair of side-cutters.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0058674 03/2008
26