GRAUPNER TERRY S Bauanleitung Seite 25

Place the canopy (18) on the fuselage and secure it by fitting the retaining screw (19)
through the slot.
Cut the Velcro (hook-and-loop) tape (20) to size and stick it in the position shown.
Apply the mating piece of Velcro tape (21) to the wing (15).
The wing
Glue the carbon fibre tube (17) in the wing as shown. Glue the aluminium screw
sleeves (16) in the wing from the top. Caution: push them into place briskly, and do
not use activator under any circumstances.
Installing the RC system
Undo the servo output screws and prise off the original output arms. Set the servos to
centre from the transmitter (or use a servo tester). Cut down the output arms (24) as
shown and fit them on the servos. Press the servos into their recesses, and apply a
drop of cyano to the mounting lugs to secure them.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0058674 03/2008
25