GRAUPNER TERRY S Bauanleitung Seite 28

Switch the motor on, and give the aeroplane a firm hand-launch directly into
any breeze; trotting forward for a few paces gives the correct launch speed.
Keep the model flying straight ahead with minimal rudder commands. If the model
tends to turn by itself, adjust the trim sliders below and adjacent to the transmitter
sticks. Move the sticks gently and smoothly initially, and keep the model flying
straight or in broad turns.
Important: initial brief application of rudder initiates a turn (the model banks);
the rudder stick should then be centred again. Holding the rudder "on" for a
long period will eventually cause the aircraft to fall into a spiral dive. Always
land the machine on the glide (motor stopped), heading exactly into wind. Reduce
the model's airspeed just before touch-down by progressively applying up-elevator.
Always land straight into any wind.
All of us at Graupner Modellbau hope you have many fine flights with your new >
TERRY S <.
Parts List - TERRY S
Part Description
No.
1 Fuselage
2 Fuselage reinforcement
3 Captive nut
4 Fin
5 Rudder snake outer sleeve
6 Elevator snake outer sleeve
7 Rudder pushrod
8 Elevator pushrod
9 Control surface horn
10 Tailplane
11 Sleeve
12 Countersunk screw
13 Insert
14 Countersunk screw
15 Wing
16 Screw sleeve
17 Carbon fibre tube
18 Canopy
19 Self-tapping screw
20 Velcro tape, fine
21 Velcro tape, coarse
22 Velcro tape, fine
23 Velcro tape, coarse
24 Servo output arm
25 Decal
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
No. off Material
1 SOLIDPOR
1 Spruce
1 Steel
1 SOLIDPOR
1 Nylon
1 Nylon
1 Steel
1 Steel
2 ABS
1 SOLIDPOR
1 Aluminium
2 Nylon
2 Nylon
2 Nylon
1 SOLIDPOR
2 Aluminium
1 CFRP
1 ABS
1 Steel
1 Nylon
1 Nylon
1 Nylon
1 Nylon
2 Nylon
10 Adhesive film
Dimensions in mm
Ready made
450 x 6 x 6
Ready made, M4
Ready made
1.9 Ø / 0.9 Ø x 380
1.9 Ø / 0.9 Ø x 440
0.8 Ø x 435
0.8 Ø x 515
Ready made
Ready made
Ready made
M4 x 16
M4 x 10
M4 x 30
Ready made
Ready made
6 Ø / 4 Ø x 390
Ready made
2.9 Ø x 16
12 x 12 x 2
25 x 15 x 2
40 x 25 x 2
40 x 25 x 2
Ready made
Sheet
Id.-Nr. 0058674 03/2008
28