Kärcher SE 2001 Bedienungsanleitung Seite 11

■ Carpets should be rinsed with clear water
after cleaning has been completed so that all
traces of detergent are removed. Allow
carpet to dry out thoroughly before walking
on it again.
■ If you use warm water (up to 50° C) you
achieve better cleaning results.
■ If the textile layer has become impregnated
with moisture after wet cleaning, we
recommend our Care Tex RM 762, which is a
dirt-repellent and anti-static proofing agent, to
help to prevent dirt building up again quickly.
When cleaning has finished
■ Switch off spray pump
■ Switch off suction turbine
■ Empty detergent reservoir.
Note: Liquid that has just been vacuumed up could
drip from the detergent reservoir while it is being
removed.
When the tubes and nozzles are pulled apart some
water may escape.
Rinse the spray tubes in the appliance
thoroughly:
■ Fill the cleaning agent container with
approximately 1 litre of clear water.
■ Hold the nozzle above the drain, and switch
on the spraying pump until the clear water
has been consumed.
■ Unplug cleaner from mains
■ Empty dirt box, and rinse out and dry if
required
Wet vacuuming
(Carpets/Hard surfaces)
(Vacuuming up moisture)
n Use spray ex nozzles to vacuum moisture or
wetness.
If you use a crevice nozzle:
Attach and secure the adapter for wet/ dry
vacuuming. Install the crevice nozzle directly
to the adapter.
Getting started
■ Remove detergent reservoir
■ Empty dirt box
■ Work without paper filter bag fitted
■ Mount motor housing onto dirt box, and lock
in place
■ Plug into mains socket
■ Switch on suction turbine
While cleaning is being carried out
The cleaner cuts out automatically when the dirt
box is full.
Note: Switch the suction turbine off after the cleaner
has cut out, otherwise the turbine will start up again
as soon as the cleaner is opened.
When cleaning has finished
■ Switch off suction turbine
■ Unplug cleaner from mains
■ Empty the dirt container. If required, rinse
inside and let dry..
If you have vacuumed sticky liquids:
■ Rinse the accessories and let dry.
(Vacuuming fine or coarse dry dirt)
Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn the
locking handle to secure it.
n Select the desired accessories and attach to
the spray/suction pipes or directly to the
attachment.
Change-over lever set to following symbol
Vacuuming hard surfaces
Change-over lever set to following symbol
Vacuuming carpets
Getting started
■ Remove detergent reservoir
■ Empty dirt box, and rinse out and dry if
required
■ The accessory (suction hose and tubes)
should be dry inside so that they don't stick.
■ Vacuuming fine dry dirt:
Fit paper filter bag (see section "Tasks to be
carried out at regular intervals").
Note: The paper filter bag may be damaged if coarse
or sharp objects are picked up by the vacuum cleaner.
■ Vacuuming coarse dry dirt:
Work without paper filter bag fitted.
■ Mount motor housing onto dirt box, and lock
in place
■ Plug into mains socket
■ Switch on suction turbine
■ Adjust vacuum power by adjusting sliding
control on handle.
English
11