Herunterladen Inhalt Inhalt Diese Seite drucken

Dry Vacuum Cleaning; Wet Vacuum Cleaning; Blowing Function; Finish Operation - Kärcher a 2675 jubilee Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Operation
Always work with an inserted car-
tridge filter - during wet as well as

dry vacuum cleaning!

Illustration
 Connect the mains plug and turn on the
appliance.
Dry vacuum cleaning
Work only with a dry cartridge filter!
Recommendation: To vacuum fine dust,
use the filter bag.
 The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
 Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
Illustration
 Vacuum cleaning of hard surfaces:
Use your foot to press the reversing switch
of the floor nozzle. The brush strips at the
bottom of the floor nozzle are extended.
Illustration
 Vacuum cleaning of carpets:
Use your foot to press the reversing switch
of the floor nozzle. The brush strips at the
bottom of the floor nozzle are retracted.
Note: Due to the high cleaning power of the
appliance the suction nozzles may get
sucked in excessively when working on
carpets, upholstery, curtains, etc. In this
case, use the supplementary air shutter to
reduce the cleaning power. Close again af-
ter use.

Wet vacuum cleaning

Illustration
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.

Blowing function

Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
 Connect the suction hose. Open the
slide of the air regulation and select the
desired blowing performance (0 – max).

Finish operation

 Turn off the appliance and disconnect
the mains plug.
 Remove the motor casing and empty
the dirt container.
Illustration
 Place the accessories in the appropri-
ate compartments at the appliance and
store the appliance in a dry room.
- 3
EN
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis