Maintenance And Care - Kärcher A 2234 PT Originalbetriebsanleitung

Illustration
Vacuuming hard surfaces
A 2534 pt / A 2574 pt :
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of
the floor nozzle are extended.
A 2234 pt:
Insert the hard surface inlay into the floor nozzle.
The bristles should point towards the front.
Vacuuming carpeted floors
A 2534 pt / A 2574 pt :
Use your foot to press the reversing switch of the
floor nozzle. The brush strips at the bottom of
the floor nozzle are retracted.
A 2234 pt:
Work without the hard surface insert.
Blowing function
Use this function, for example, to blow out
leaves or dust from the garage, workroom or
work shop.
Illustration

Connect connection hose. Open the slide of
the air regulation, and select the desired
blowing performance.
Wet vacuum cleaning
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes the
suction opening and the appliance works at a
higher speed. Switch off the appliance immedi-
ately and empty the container.
Working with electrical power tools

Adapt the adapter to the connection diame-
ter of the electric tool using a knife if neces-
sary.
Illustration
Electric power tools with a power consumption
of 100-2100 W can be connected.
A 2234 pt
EU 100 - 2100 W
CH 100 - 1100 W
GB 100 - 1800 W
A 2534 pt
A 2574 pt
100 - 2100 W
100 - 900 W
100 - 1600 W

A) Plug the enclosed adapter onto the suc-
tion hose and connect the electric tool with
the connection.
or

B) Use hose Flex-Tool; attach the thicker
end directly to the surction hose and the oth-
er end on the enclosed adapter and connect
it to the electric tool.
Illustration

Connect the mains plug of the electric power
tool to the vacuum cleaner.

Switch the vacuum cleaner to Position II
and start working.
Note: The suction turbine starts with a delay
of 0.5 seconds after the electric tool has
been switched on. After the electric tool has
been switched off, the suction turbine will
continue to run for approx. 5 seconds to
suck in the remaining dirt from the suction
hose.
Finish operation

Turn off the appliance and disconnect the
mains plug.
Empty the container
Illustration

Remove the motor casing and empty the
container.
Storing the Appliance
Illustration

Place the accessories in the appropriate
compartments at the appliance and store
the appliance in a dry room.
Transporting the device

The device is to be fastened properly before
transporting the device in the car.

Maintenance and Care

Risk of injury
Always switch off the appliance and pull out the
mains plug before care and maintenance work.
Cleaning the appliance and accessories
Caution
Do not use abrasives, glass or universal clean-
ers! Never immerse the appliance in water.

Clean the appliance and accessory parts
made of plastic with a commercial plastic
cleaner.
English 9
9
English