Employ exclusively the enclosed battery charger.
• Operate the battery charger only on fire resistant surfaces and
• Also place the battery on a non-inflammable surface while char-
ging.
• Ensure for sufficient ventilation of the battery charger while char-
ging.
G
Never subject the battery charger, the batte-
ries and the model to adverse local conditions!
These are for instance:
• Wetness, too high air humidity (> 75% rel., condensing). Do not
touch the battery charger with wet hands.
• Never operate the battery charger right after it has been brought
from cold into warm surroundings. The resulting condensation
water can destroy the device. Permit the device to attain the
ambient temperature while unconnected.
• Dust and inflammable gases, vapours or solvents, benzene
• Too high ambient temperatures (> about +40°C), direct solar
radiation
• Open fire, ignition sources
• Mechanical stresses such as shocks, vibrations
• Strong contamination
• Strong electromagnetic fields (motors or transformers) or electro-
static fields (charges)
• Transmitters (radio telephones, transmitters for model building
etc.). The transmitter radiation can lead to the malfunction of the
charging operation or to the destruction of the battery charger
and thereby also of the batteries.
Lithium-Polymer battery
Employ the enclosed battery exclusively for this model.
Only employ an original part as a replacement battery.
• Do not overload or exhaustively discharge the battery! Both can
cause that electrolyte leaks out and lead to self-ignition.
• Never mix fully charged batteries with half-charged ones or bat-
teries with different capacity.
• Charge the LiPo battery at least every two months in order to
avoid low discharging.
• Remove the charged battery from the battery charger in order to
avoid self-discharging.
At the end of its useful life, under various national/state and local
laws, it may be illegal to dispose of this battery into the municipal
waste stream. Check with your local solid waste officials for details in
your area for recycling options or proper disposal.
22
CARSON X4 Quadcopter 360 FPV WIFI 500507101
• Never leave the battery charger unattended during the charging
process.
• Never mix fully charged batteries and batteries which have already
run low, or batteries of a different capacity at the same time.
• When charging the batteries pay attention to the correct polarity.
Permit the battery charger to cool down bet-
ween charging operations. Disconnect the bat-
tery charger from the power when the charging
operation is finished.
A defective battery charger may no longer be employed. If it is assu-
med that the device is defective, i.e. if
• The device shows visible damage,
• The device no longer works and
• After longer storage under unfavourable conditions or
• After severe transportation stress, then it should be made inopera-
tive without delay and secured against unintentional operation.
Dispose of the unusable (irreparable) battery charger according to the
prevailing statutory regulations.
For safety and registration reasons (CE), the arbitrary reconstruction
and/or modification of the battery charger is not permitted.
The batteries must not
• Be immersed in liquid,
• Be thrown in the fire or subjected to high temperatures or
• Mechanical stresses or
• Be taken apart or damaged
• Or be short-circuited.
If during operation or while charging or storing the battery you
perceive a noticeable smell, a discolouration, excessive heating or
deformation or any other abnormality:
• Disconnect the battery from the battery charger
• Separate the battery from the consumer
• No longer employ the battery..
If electrolyte drains out:
• Avoid contact with eyes and skin!
• Wash the affected locations immediately with clear water and
• Consult a physician.