Yamaha CLP-611 Bedienungsanleitung Seite 53

1. NOTE ON/OFF
[9nH] → [kkH] → [vvH]
9nH = Note ON/OFF event (n = Channel No.)
kkH = Note No.
(Sending: 09H~78H = A-2~C8)
(Receiving: 00H~7FH = C-2~G8) *1
vvH = velocity
(Note ON = 01H~7FH. Note OFF = 00H.)
[8nH] → [kkH] → [vvH]
8nH = Note OFF (n = Channel No.)
kkH = Note No. (00H~7FH = C-2~G8)
vvH = velocity
*1: If received value exceeds the supported range
for the selected voice, the note is adjusted by
the necessary number of octaves.
2. Control Change
[BnH] → [ccH] → [vvH]
BnH = Control Change (n = Channel No.)
ccH = Control No.
vvH = Control value
1) Bank Select
ccH Parameter
00H Bank select MSB 01H: Normal
20H Bank select LSB 00H~7FH
70H Brilliance: Normal Variation: OFF
71H
72H
73H
74H
75H
* Bank selection processing does not occur until
receipt of next Program Change message.
* Bank Select messages are not effective on the
Organ Combination voice.
2) Main Volume (Receive only)
ccH Parameter
07H Volume
3) Expression
ccH Parameter
0BH Expression
4) Damper Pedal
ccH Parameter
40H Damper
5) Sostenuto Pedal
ccH Parameter
42H Sostenuto
6) Soft Pedal
ccH Parameter
43H Soft pedal
7) Attack Time
ccH Parameter
49H Attack time
8) Effect-1 Depth (Reverb Send Level)
ccH Parameter
5BH Effect-1 depth
* Adjusts the send level for the reverb effect.
9) Effect-4 Depth (Variation-Effect
Send Level)
ccH Parameter
5EH Effect-4 depth
3. Mode Messages
[BnH] → [ccH] → [vvH]
BnH = Control Event (n = Channel No.)
ccH = Mode Message No.
vvH = Mode Message value
50 MIDI Data Format/MIDI-Datenformat/Format de données MIDI/Formato de datos MIDI
CLP-811/611
1) All Sound Off
ccH
78H
* Turns off all sound on the specified channel.
Does not reset Note On and Hold On conditions
established by Channel Messages.
2) Reset All Controllers
ccH
79H
* Resets controllers as follows.
Controller
Expression
Damper Pedal
Sostenuto
Soft Pedal
3) All Notes Off
ccH
7BH
* Switches OFF all the notes that are currently ON
on the specified channel. Any notes being held
by the damper or sostenuto pedal will continue
to sound until the pedal is released.
Value (vvH)
4) Omni Off (Receive only)
00H~7FH: Incorrect sounding
ccH
7CH
* Same processing as All Notes Off.
Normal ON
Bright OFF
5) Omni On (Receive only)
Bright ON
ccH
Mellow OFF
7DH
Mellow ON
* Same processing as All Notes Off.
6) Mono (Receive only)
ccH
7EH
* Same processing as All Sound Off.
Value (vvH)
7) Poly (Receive only)
00H~7FH
ccH
7FH
Value (vvH)
* Same processing as All Sound Off.
00H~7FH
Remarks
1. The Clavinova will not send or accept Control
Value (vvH)
Change messages if the FUNCTION-mode
00H~7FH
Control Change setting is OFF.
2. The Clavinova does not transmit Local ON/OFF
and Omni ON/OFF messages. (All Notes Off is
Value (vvH) transmitted as a series of Note Off messages.)
00H~3FH:OFF 40H~7FH:ON 3. The Clavinova saves the bank select value (MSB
and LSB; receivable in any order) to its internal
buffer. This value is then used to determine the
voice selection upon receipt of the next Program
Value (vvH)
Change message.
00H~3FH:OFF 40H~7FH:ON
4. The Clavinova always operates in multitimbral
polyphonic mode. The mode does not change in
response to Omni ON/OFF, Mono, and Poly
Value (vvH)
messages.
00H~7FH
4. Program Change
[CnH] → [ppH]
Value (vvH)
CnH = Program Change (n = Channel No.)
00H~7FH
ppH = Program Change No.
* The Clavinova will not send or accept Program
Change messages if the FUNCTION-mode
Program Change setting is OFF.
* Program number assignments are as follows.
Value (vvH)
00H~7FH
Voice
PIANO 1
PIANO 2
CLAVI. TONE
E. PIANO 1
E. PIANO 2
HARPSICHORD
VIBES
STRINGS
Controller Value (vvH)
All Sound Off 00H
Controller Value (vvH)
Reset All Controllers 00H
Reset Value
127 (Max.)
0 (OFF)
0 (OFF)
0 (OFF)
Controller Value (vvH)
All Notes Off 00H
Controller Value (vvH)
Omni Off 00H
Controller Value (vvH)
Omni On 00H
Controller Value (vvH)
Mono 00H
Controller Value (vvH)
Poly 00H
Program Change No.
00H
01H
58H
05H
04H
06H
0BH
30H
CHOIR 34H
PIPE ORGAN 13H
ORGAN CONBINATION 10H
BASS (CLP-811) 20H
5. System Realtime Messages
1) Active Sensing
[FEH]
* Transmitted every 200 msec.
* If the Clavinova receives no MIDI signals for
400 msec. following receipt of an FEH, it will
execute processing equivalent to All Sound Off
→ All Notes Off → Reset All Controllers.
2) Clock
[F8H]
* Clock signal is issued 96 times per whole note.
* If Exclusive Message specifies use of an external
clock, the Clavinova counts 96 clock signals as
one whole note.
3) Start
[FAH]
* Transmitted at rhythm start.
* Receipt causes song to start.
4) Stop
[FCH]
* Transmitted at rhythm stop.
* Receipt causes song to stop.
* If error occurs during MIDI reception, the
Clavinova switches off damper, sostenuto, and
soft effects and then executes All Notes Off
processing (for all channels).
6. System Exclusive Message
(Yamaha MIDI Format)
[F0H] → [43H] → [0nH]→ [7CH] → ... → [F7H]
F0H,43H,0nH,7CH: n = Channel No.
01H,36H: Data length
43H,4CH,20H,20H: CL
43H,4CH,50H,27H,39H,36H: CLP'96
30H,30H: (Version x,y)
[Panel Data]
[Checksum (1 byte)]=0-(43H+4CH+20H+..... data end)
F7H: End of Exclusive
[Panel-data content]
(1) Voice
(2) DUAL ON/OFF
(3) DUAL voice
(4) DUAL balance
(5) DUAL detuning
(6) DUAL Voice # 1 octave shift
(7) DUAL Voice # 2 octave shift
#
(8) DUAL Voice 1 effect depth
(9) DUAL Voice # 2 effect depth
(10) DUAL/STRINGS slow attack ON/OFF
(11) SPLIT ON/OFF
(12) SPLIT voice
(13) SPLIT point
(14) SPLIT balance
(15) SPLIT Voice # 1 octave shift
#
(16) SPLIT Voice 2 octave shift
(17) SPLIT Voice # 1 effect depth
#
(18) SPLIT Voice 2 effect depth
(19) SPLIT damper mode
(20) Reverb type
(21) Reverb depth
(22) Effect type 1
(23) Effect type 2
(24) Effect depth
(25) Brilliance
(26) Variation # 1 ON/OFF
#
(27) Variation 2 ON/OFF
(28) Touch sensitivity
(29) FIXED-touch velocity
(30) Left pedal function (Soft/Start)
(31) Key-specific tuning ON/OFF
(32) Tempo (absolute value; LSB)
(33) Tempo (absolute value; MSB)
(34) Organ Combination voice No.
(35)~(51) Organ Combination data 1