Cleaning And Maintenance; Daily Cleaning After Completion Of The Slaughters - EFA SK18 WB Betriebsanleitung

Saw is unusually loud
(motor or gear head)
Brush sparking in motor
Saw blade "wobbles"
No cutting performance

6. Cleaning and maintenance

Disconnect the machine from the
works mains before all cleaning
and maintenance work!
6.1 Daily cleaning after completion
of the slaughters
Continuous reliable operation can only be assured if
the breaking saw is kept hygienically clean at all
times. The machine should normally be disinfected
before each cleaning.
Observe the applicable safety and hygiene regulati-
ons (DIN EN 1672)!
Disinfectants must not be allowed to come into di-
rect or indirect contact with foodstuffs. Rinse the
machine with clear water after every disinfection.Di-
Do not use aggressive solvents!
Do not use steam or high-pres-
sure cleaners! Do not immerse
the machine in water!
sinfection
Disinfect the machine during operation after every
cut with hot water (82° C).
6.1.1 Cleaning the breaking saw
Clean the machine after use with a cloth, brush and
warm water (40 - 55° C). Stubborn or encrusted soi-
ling must be soaked beforehand. Clean using a cle-
Schmid & Wezel
D 75433 Maulbronn
Table 2: Troubleshooting
15. Motor bearings (5+6) defective
16. Bearings in gear head defective
(56,58,65 or 68)
17. Bevel gear pair (55) teeth worn
18. Armature (5) soiled or defective
19. Carbon brushes (15) worn
20. Saw blade (85) not correctly
mounted or secured
21. Bearing (65 or 68) defective
22. Saw blade blunt
aning agent, preferably as a foam, that is applied to
the surface to be cleaned and allowed to work for 15
- 20 minutes. Subsequently wash off the dissolved
soiling manually with warm water.
Cleaning must be carried out outside the breaking
shop in the maintenance room where the saw blade
can be removed (see Chapter 4.1).
Recommended cleaning agents
A cleaning plan and further details can be obtained
from the above addresses.
The above cleaning agents are only a recommenda-
tion; if other cleaning agents are used, the customer
should examine the material compatibility and the
compliance with the hygiene regulations.
6.1.2 Lubricants and hydraulic oil
Recommended lubricating grease
Klübersynth UH1 14-1600 (H1) special gearbox
grease
Order No. 001 365 644 (0.8 kg)
Order No. 001 365 645 (5 kg)
Seite/ Page
18/ 27
Inspect, replace if necessary
Inspect, replace if necessary
Inspect, replace if necessary
Inspect and clean armature (see
chapter 4.4), replace if necessary
Inspect, replace if necessary
Chapter 4.4
(see
Inspect saw blade mounting
(square drive), replace if neces-
sary and secure with nut (74)
Inspect, replace if necessary
Sharpen or replace saw blade
Diversey Lever Tego 2000: Surface-active disin-
fectant
Diversey Lever GmbH
Mallaufstr. 50-56, 68219 Mannheim
P3-topax 91: Surface-active disinfectant
Henkel-Ecolab Deutschland GmbH
Postfach 13 04 06, 40554 Düsseldorf
)
Ausführung/ Version
05.2007