Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Assembly
Disconnect the saw from the
mains power supply before all
assembly work.
4.1 Changing the saw blade
Use only original EFA saw blades!
Insert the retention pin supplied into the saw
blade bore (A) as a twist lock and turn the saw
blade until the retention pin contacts the safety
hood (see Fig. 3)
Remove the hex. nut using the single-head
wrench supplied - turn in anti-clockwise direc-
tion (arrow B). (see Fig. 3)
Figure 3: Loosening the saw blade
Replace the saw blade. Place the new saw blade
onto the square drive (see Fig. 4).
Figure 4: Fitting the saw blade
Insert the retention pin as a twist lock into the
saw blade bore and the bore below (A) (see Fig.
5).
Tighten the hex. nut securely - turn in clockwise
direction (arrow B) and tighten to approx. 50
Nm (see Fig. 5).
Schmid & Wezel
D 75433 Maulbronn
Figure 5: Fixing the saw blade
Remove single-head wrench and retention pin.
Carry out a test run.
4.2 Sharpening the saw blade
We have set up a sharpening service in our Service
department. Incorrectly resharpened saw blades
detract from your productivity and also constitute
considerable risks for the user.
An overview of our product range for saw blades
can be seen in Table 1: EFA 18 WB and Fig. 6 :
Teeth
Fig.
(mm)
A
3.5
B
6
B
8
D
40.5
E
Special
F
15.5 (HM)
Seite/ Page
15/ 27
Table 1: EFA 18 WB
No. of
Diame-
teeth
ter (mm)
160
180
94
180
70
180
14
180
-
180
36
180
Ausführung/ Version
Order No.
003 003 828
003 005 185
003 006 612
003 003 828
001 624 418
003 004 917
05.2007
Werbung
Inhaltsverzeichnis
