Daily Maintenance Of The Breaking Saw; Extended Maintenance (After Approx. 50 Operating Hours); Repair By After-Sales Service; Transport And Storage - EFA SK18 WB Betriebsanleitung

6.2 Daily maintenance of the brea-
king saw
6.2.1 Saw blade
Remove the machine from the breaking shop and
transport it to the maintenance room or workshop
where the saw blade can be removed.
Inspect the saw blade at regular intervals. If the
self-locking effect of the hex. nut is no longer assu-
red, it must be replaced without delay.
6.3 Extended maintenance (after
approx. 50 operating hours)
6.3.1 Breaking saw
In order to ensure the lubrication of the ball bea-
rings and the gear head, the machine must be
greased at the grease nipples using a grease gun (3
strokes at each nipple). (see Annex A.4 "Explosi-
onszeichnung/ Exploded view" (p. 25))
6.3.2 Brake
If the event of brake malfunctions, this must be im-
mediately inspected and replaced, if necessary for
safety reasons. If the run-down time is longer than
3 seconds, the brake must be urgently repaired.
6.3.3 Sharpening the saw blade
Remove the machine from the breaking shop and
transport it to the maintenance room or workshop
where the saw blade can be removed.
Incorrectly resharpened saw blades detract from
your productivity and also constitute considerable
risks for the user.
We have set up a sharpening ser-
vice for you in our Service depart-
ment. In this case, please contact
your nearest contract workshop or
our main company directly.
Sharpening can also be carried out on commercially
available automatic circular saw blade sharpening
machines. See also Chapter 4.2.
Do not use force as parts could be
damaged! Use only original EFA
spare parts!
Schmid & Wezel
D 75433 Maulbronn

6.4 Repair by After-Sales Service

Disconnect the machine from the
works mains before starting any
repair work!
Repairs may only be carried out by authorised
specialists.
Our Service department is at your disposal for
all repair work. In the event of a repair, please
contact your nearest contract workshop or our
parent company directly.
On request, spare parts lists can be supplied to
the repair workshop with qualified specialist
staff.

7. Transport and storage

The machine must be stored in a dry, well-ventilated
room.
The machine must be cleaned as described in Chap-
ter 6.1.1 and transported in dry condition.
Ensure that the machine is not damaged during
transport.

8. End of life provisions

At the end of their useful service life, return old ma-
chines to the parent company for disposal.
Seite/ Page
19/ 27
Ausführung/ Version
05.2007