Scheppach HL1000v Originalanleitung Seite 15

Transport
Transport by hand, Fig. 3
For transport, the splitting knife A must be completely
moved down. Slightly tilt the log splitter with handle B on
the splitting column until the machine is inclined on the
wheels and can be moved.
Transport by crane:
Never lift the machine on the splitting knife!
Storing conditions:
The following conditions are required:
• Dry storing place under roof
• Maximum humidity 80 %
• Temperature range -20 °C to +60 °C
The machine should operate under the following environ-
mental conditions:
minimum
Temperature 5 C°
Humidity
Setting up
Prepare the work place where the machine is to stand.
Create sufficient space in order to allow safe working
without disturbance.
The machine has been designed for working on a level
surface. It must therefore be set up in a stable position
on firm ground.
Assembly
For reasons of packing, your scheppach log splitter is not
completely assembled.
Fitting the operating arms, Fig. 4
• Insert the control arm (A) in the rocker switch (C), and
screw it in place with the hexagon bolt (D), the washer
(E) and the safety nut. Tighten the lock nut so the con-
trol arm can still be moved.
• Now, mount the control arm (B) on the right, following
the method described above.
• Mount the hoop guards (F) to both control arms, using
2 crosshead screws (G) in each case.
maximum recommended
40 C° 16 C°
95 % 70 %
Transport
Ročni transport, Slika 3
Med transportom mora biti cepilni nož v najnižji poziciji.
Počasi nagnite cepilnik z ročico B na cepilni drog dokler
ni stroj nagnjen na kolesa in ga lahko premaknete.
Transport z žerjavom:
Nikoli ne vzdignite stroja s cepilnim nožem!
Razmere za shranjevanje:
Sledeči pogoji so zahtevani:
• Suh prostor s streho
• Maksimalna vlažnost 80 %
• Temperaturno nihanje -20 °C do +60 °C
Stroj lahko obratuje pod sledečimi okoljskimi pogoji:
minimum
Temperatura 5 C°
Vlaga
Priprava
Pripravite območje kjer bo stroj stal. Pripravite dovolj
prostora, da bo delo s strojem varno in bo potekalo brez
motenj.
Stroj je bil načrtovan za delo na ravni površini. Zato ga
čvrsto postavite na trdna in ravna tla.
Montaža
Zaradi pakiranja in transporta vaš scheppach cepilnik le-
sa ni v celoti sestavljen.
Pričvrstitev delovnih ročic, Slika 4
• Vstavite kontrolno ročico (A) v premično stikalo (C), in
jo privijte s šestkotnim izvijačem (D), podložko (E) in
varnostno matico. Privijte zapiralno matico toliko, da
se kontrolna ročica še vedno lahko premika.
• Zdaj montirajte kontrolno ročico (B) na desno in sledite
metodi opisani zgoraj.
• Pritrdite objemke (F) na obe kontrolni ročici z uporabo
2 križnih izvijačev (G) velja za obe objemki.
maksimum priporočeno
40 C° 16 C°
95 % 70 %
15