Electrical Connection - SILANOS 1000 Gebrauchsanweisung

4.2

ELECTRICAL CONNECTION

The appliance is to be connected to a wall master switch of suitable power, provided with a
thermal release and the relevant switch unit. Three-phase models must be provided with a
power cable of suitable ength, H07RN-F type.
Attention: the grounding system is to be connected in full compliance with the current
regulations. Moreover, the appliance is to be set within an equipotential system by
connecting the screw located on the base and marked by the relevant sign. The
Manufacturer will not be liable for any direct or indirect damage arising from non-com-
pliance with the said regulations.
Before wiring the appliance assure that:
- the operating voltage rate corresponds to the rate shown on the appliance rating plate;
- wiring is carried out in accordance with wiring diagram.
4.2.1 VOLTAGE CHANGE
Voltage may be changed from 400V/3+N 50Hz to 230V/3 50Hz if appliance model is
three-phased. In order to change voltage, the neutral wire in the terminal board inside the
appliance must be connected to phase L3 and the boiler resistor must be connected as shown
on the wiring diagram.
5 FINAL SETUP OPERATIONS
- Turn water supply tap on and switch the wall master switch on.
- Make sure that there are no foreign bodies inside the dishwasher.
- Check that all the covering panels are fitted.
- Check that the overflow pipe (Fig. 10 - Pos. H) is correctly positioned and secured.
- Check that the surface filters are fitted correctly in their places (Fig. 6).
- Make sure that the hood is closed.
- Move the main switch 2 to the 1 position. The power pilot light 1 will come on and at the
same time the boiler andthe tank will start to fill and the heating resistances will come on.
- When the machine has reached a temperature of 50 °C in the tank and 85 °C in the boiler
(light 4 off), add non-foaming liquid detergent to the tank: about 50 cl. for the first load and
then about 25 cl. every 4/5 washes. In any case, follow the instructions for the dosage
recommendations provided by the manufacturer of the products.
6 POLISHING LIQUID DISPENSER
All models are equipped with an automatic polishing diaphragm dispenser.
As supplied, dispensers are tested at the highest capacity so as to be later adjusted according
to the polisher type being used. Adjustments are carried out by means of screw P (Fig. 11),
which may be rotated anticlockwise to increase the capacity and clockwise to decrease the
capacity.
The exact quantity of polishing liquid required for each rinse cycle is automatically released.
Adjustments should be carried out by detergent suppliers.
ENGLISH 22