SILANOS 1000 Gebrauchsanweisung Seite 24

11 STARTING
Wait until the machine has reached the right temperature (light 4 off), carry out one empty
cycle then place the basket in the dishwasher having removed leftovers and scraps from the
dishes.
Mod.E 1000
- Set the main switch 1 to "on"
· Wait until the boiler light indicator pos.4 goes off
· Close the capote to start the washing cycle
· The light indicator pos.3 will remain on for the whole cycle.
Mod.N 1000 - N 1000 B
· Position the main switch 1 to « on »
· Select the cycle time with the button pos.4
· Light indicator pos.6 on = short cycle - light off = long cycle
· Wait until the thermometer temperature reaches 75°/80°C.
· Close the capote to start the washing cycle.
· The light indicator pos.3 will remain on for all the cycle time.
Mod.N 1300 - N 1300 B
· Set the main switch 1 to "on"
· Set the cycle time with the selector pos.5
· Wait until the thermometer temperature reaches 75°/80°C.
· Close the capote to start the washing cycle
· The light indicator pos.3 will remain on for all the cycle time.
When the rising cycle has ended (light indicator pos.3 off) lift the capote, remove the basket and
leave it for a few minutes in the air, thus favouring the drying of the tableware.
If the capote is opened during the programme, this stops and restarts only after its closing. With
particularly dirty tableware, it is advisable to frequently clean the surface filters.
11.1 MODELS WITH WASTE PUMP
The machine automatically waste the water and keeps the level of the same constant
inside.To empty the tank completely,move the general switch 1 located on the control panel to
"0 ".Press button 9 as shown in the figure;wait until the tank has been completely emptied.
During the use the machine automatically discharges the water and keeps the level of the same
constant inside the tank.
ENGLISH 24