Automatic Call Acceptance - Silvercrest SBTF 10 C2 Bedienungsanleitung

Accepting and ending a call
GB
When you receive a call the LED status indicator 7 blinks
CY
and you hear a call tone from the hands-free appliance.
If the call signal in your mobile phone is switched off , the
ringing tone is nonetheless sounded via the hands-free
appliance.
Press the multi-function button 6 shortly once,
to accept the call.
Press the multi-function button 6 shortly once,
to terminate the accepted call.
You can also accept and terminate the call over the
mobile telephone.

Automatic call acceptance

If automatic call acceptance is activated in the mobile tel-
ephone, it accepts the incoming call after a determined time
period and then passes it on to the hands-free appliance. Fur-
ther information regarding automatic call acceptance is to be
found in the operating instructions for your mobile telephone.
Rejecting a call
Press the multi-function button 6 for 3 seconds to
reject an incoming telephone call.
Adjusting the volume of the hands-free appliance
You can adjust the sound volume level of the hands free
device with the +/- buttons 3.
During a call, repeatedly press the + resp. - buttons 3
until the desired sound volume level is obtained.
A high-pitched beep signals that you have reached
maximum volume; a low-pitched beep signals that you
have reached minimum volume.
12
SBTF 10 C2