Replacing The Fuse - Silvercrest SBTF 10 C2 Bedienungsanleitung

Replacing the fuse

GB
The hands-free set is equipped with a fuse. If the device
CY
no longer works, check the fuse and replace if necessary.
Open the vehicle connector plug 1 by turning the
fl uted screw insert
if necessary – and remove it.
Remove the plug tip
out. Ensure that the spring
plug 1 does not accidentally jump out and become lost.
Place a new fuse of type F2AL/250V into the vehicle
connector plug 1, place the plug tip
of the fuse that is slightly protruding
screw insert that you removed earlier
Risk of fi re!
Replace the fuse only with another of the same rating
as that given on the ratings plate. Fuses with a diff erent
rating may cause fi re. Smoke resulting from such a fi re
is poisonous.
Note:
If these measures do not correct the problem, please con-
tact the appropriate service partner for your country.
14
D
gently anticlockwise – with pliers
A
from the fuse
B
in the vehicle connector
D
C B A
and pull the fuse
C
onto the end
B
and screw the
C
back in.
A
SBTF 10 C2