Show Saved Code; Normal Operation; Operating Individual Devices - Medion LIFE E74003 Handbuch

Show saved code

You will be able to display the stored code for each device. You will be able to
make note of the codes in this way, so that you will not have to search again
later. Proceed in the following way:
 Press down the source key of the device of which the code is intended to be
displayed (TV1, TV2, SAT1, SAT2, DVD, VCR, AUDIO, TUNER, TAPE,
AUX), together with Key 1. The first digit of the four-digit will be displayed,
while the red LED is flashing. The number of flashes of the LED will give the
number of the first digit. The LED will not flash if the digit is 0.
 Press down the source key of the device, together with Key 2, to have the
second digit of the code displayed. The second digit of the four-digit code
will be displayed, while the LED is flashing.
 Press down the source key of the device, together with Key 3, to have the
third digit of the code displayed. The third digit of the four digit code will be
displayed, while the LED is flashing.
 Press down the source key of the device, together with Key 4, to have the
fourth digit of the code displayed. The fourth digit of the four-digit code will
be displayed, while the LED is flashing.
Example
The code of a DVD player is 0351. Proceed as follows:
 Press down DVD and 1 at the same time. The LED will not flash (0).
 Press down DVD and 2 at the same time. The LED will flash three
times (3).
 Press down DVD and 3 at the same time. The LED will flash five times
(5).
 Press down DVD and 4 at the same time. The LED will flash once (1).

Normal operation

Operating individual devices

After you have finished programming your remote control for your audio/video
devices, the remote control will work in the common main functions just like the
original remote control of the respective device.
Point your remote control at the desired device and press the relevant source
key. Use the remaining keys as usual. With every transmission the green LED will
light up briefly.
Activate the functions by pressing the corresponding function key of your
universal remote control. The LED will light up briefly each time the key is
pressed.
Please note:

In certain circumstances, not every function of your original remote
control may be directly available on the universal remote control.

Especially for newer devices, it might be possible that the functions
are stored to different keys or may not even be available at all.
10