Operating Combined Devices; Learn Function - Medion LIFE E74003 Handbuch

Operating combined devices

Some combined devices (e.g. TV set with an integrated video recorder) require
two device codes - one for each device part. The combined device is then
controlled like two separate devices.
If your combined unit only requires one code but you would like to operate it
with two source keys, then proceed as follows:
1 Programme the device code to two source keys.
2 Operate one of the unit parts with one of the two source keys.
3 Use the learn function (see following chapter) to transfer the desired
functions of the other unit part to the other source.

Learn function

You can manually save the functions of an original remote control to your
universal remote control.
Notes on learn function

Use new batteries for both remote controls.

Only one original remote control can be programmed on each source key.

No more additional programming will be accepted, if the memory is full.

When you would like to programme an additional function to an existing
code, check which keys aren't already in use.

The following keys cannot be assigned to functions: LEARN, ALL OFF,
.
M1,

Some original remote controls (for DVD, video recorder, SAT) can
themselves be programmed with the device codes of some TV brands to
carry out basic TV set functions (volume, mute, channel search). Do not
attempt to transfer the functions of an original remote control that has been
programmed with the code of a different TV set to your universal remote
control. This could cause programming errors.

First try to program two or three commands and then test them.

Before programming in your commands, first delete all existing commands
(see page 12).

Do not execute the learn function under a low-energy lamp. Such lamps
(e.g. fluorescent lamps) can contain infrared light components that could
influence the learn function.
ES
EN
DE
11