Yamaha M2500 Bedienungsanleitung Seite 16

F ON/EDIT switch / ON, CHECK indicators
The function of this switch and these indicators will
change depending on the mode of the M2500.
In normal mode
You can use the ON/EDIT switch to turn each G1/
A7–G8/A14 channel on/off. When the channel is
switched on/off, the ON indicator will be lit/dark to
indicate the status. Channels that are switched off will
not send any signals to the STEREO, MONO/C, or
MATRIX buses.
In check mode
When a scene (which contains the on/off state of the
ON/EDIT switches) is selected, the on/off status
memorized in that scene will be indicated by the lit/
dark status of the CHECK indicator. In check mode,
you can also use the ON/EDIT switch to switch the
CHECK indicator between lit/dark. (The current on/
off setting will not be affected.) For details on check
mode, refer to page 32.
GROUP AUX
1 3 5 7 1 3 5 7 9 11
2 4 6 8 2 4 6 8 10 12
INSERT I/O
0dB
13
G1/A7
14
6
CHECK
ON
Control
ON/EDIT
from CPU
GROUP
AUX
GROUP/AUX FLIP
G Fader
This adjusts the output level of the GRP/AUX OUT.
H AFL (after fader listen) switch
This switch allows you to monitor the signal of the
G1/A7–G8/A14 section from the MONITOR OUT/
PHONES jacks. If the input channel PFL switches are
all off, turning this AFL switch on (the indicator
above the switch will light) will allow you to monitor
the corresponding G1/A7–G8/A14 section signal
from the MONITOR OUT/PHONES jacks. The
monitor signal can be switched between pre/post-
fader using the MASTER PFL switch of the monitor
section.
7
to METER
GRP/AUX OUT
+4dB
G1/A7
PAN ST
4
MONO
LCR
MATRIX
8
AFL
to METER
AUX/GRP OUT
+4dB
A7/G1
ON
LEVEL
1 2
AFL
3
GRP/AUX G2/A8-G8/A14
and
AUX/GRP A8/G2-A14/G8
Same as
G1/A7
and
G7/A1
MATRIX
L R L R L R
5
M2500—Owner's Manual
Control panel
MONITOR
INPUT MASTER
(PFL) PFL AFL
L R L R L R
13