Stereo Input Channel Input/Output Jacks - Yamaha M2500 Bedienungsanleitung

Rear panel
Stereo input channel input/
output jacks
C INPUT A jacks
These are XLR-3-31 type input jacks (balanced) for
stereo input channel 1. Nominal input level is +10 dB
to –30 dB. In order to use these jacks, you must set
the A/B select switch of stereo input channel 1 to the
A position. The pin wiring is as follows.
Male XLR plug
D INPUT B jacks
These are RCA phono input jacks (unbalanced) for
stereo input channel 1. Nominal input level is +10 dB
to –20 dB. In order to use these jacks, you must set
the A/B select switch of stereo input channel 1 to the
B position. The pin wiring is as follows.
RCA phono plug
26
M2500—Owner's Manual
ST CH 4 ST CH 3
INPUT INPUT
L/MONO L/MONO
5
R R
DC POWER INPUT
READ OWNER'S MANUAL
1 (ground)
3 (cold)
2 (hot)
Tip (send)
Sleeve (ground)
ST CH 2 ST CH 1
INPUT INPUT A
L/MONO
L
3
R
R
PHANTOM
MASTER
INPUT B
OFF ON
L
4
R
E INPUT jacks
These are TRS phone input jacks (balanced) for ste-
reo input channels 2–4. Nominal input level is
+10 dB to –30 dB. The pin wiring is as follows.
If you wish to input a monaural signal to stereo input
channels 2–4, insert a plug only into the L/MONO
jack. In this case, the signal that is input to the L/
MONO jack will be sent to both L and R of the stereo
input channel.
Hot
Cold
Ground