Yamaha M2500 Bedienungsanleitung Seite 15

Control panel
GROUP/AUX FLIP switch= AUX (
The signals of AUX buses 7–14 will be sent to chan-
nels G1/A7–G8/A14 respectively, and will be output
individually from the GRP/AUX OUT G1/A7–G8/
A14 jacks.
MATRIX
AUX5
0 10
AUX6
0 10
AUX7
0 10
AUX8
PRE
0 10
AUX9
0 10
AUX10
12
M2500—Owner's Manual
)
PAN PAN
C C
L R L R
ST MATRIX ST
MONO MONO
LCR LCR
CHECK CHECK
ON ON
ON/EDIT ON/EDIT
10 10
5 5
0 0
5 5
10 10
20 20
30 30
40 40
50 50
60 60
AFL AFL
G1 / A7 G2 / A8
D PAN control
This adjusts the pan of the signal that is sent from the
G1/A7–G8/A14 section to the STEREO or MONO/C
bus. The function of the PAN control will change as
follows, depending on the setting of the channel
assign switch (5).
When the ST switch is on
PAN will adjust the pan of the signal that is sent from
each channel to the STEREO L/R bus.
When the LCR switch is on
PAN will adjust the pan of the signal that is sent from
each channel to the STEREO L/R bus and MONO/C
bus.
E Channel assign switches
These switches assign the post-fader post-PAN signal
to the desired bus.
• ST (stereo) switch
If this switch is on (
output channel will be sent to the STEREO bus.
• MONO (monaural) switch
If this switch is on (
channel will be sent to the MONO/C bus.
• LCR switch
If this switch is on, the indicator above the switch will
light, and the post-PAN signal of the output channel
will be sent to the STEREO bus and the MONO/C
bus.
• MATRIX switch
IF this switch is on (
channel will be sent to the corresponding MATRIX
bus.
Note:
• The LCR switch takes priority over the ST/
MONO switch. If the LCR switch is on, the
post-PAN signal of the G1/A7–G8/A14 section
will be sent to the STEREO bus (L/R) and
MONO/C bus regardless of the on/off status of
the ST/MONO switch. (Refer to response curve
diagram 1 on page 4.)
• If the LCR switch is off, the ST/MONO switch
will function as a conventional channel assign
switch. If ST is on, the post-PAN signal of the
G1/A7–G8/A14 section will be sent to the ST
bus. If the MONO switch is on, the signal of
the G1/A7–G8/A14 section will be sent directly
to the MONO/C bus. (Refer to response curve
diagram 2 on page 4.)
), the post-PAN signal of the
), the signal of the output
), the signal of the output