Operating Determinations - EuroLite LED FE-1500 Bedienungsanleitung

3

OPERATING DETERMINATIONS

Areas of Use
• This device is designed for private and professional
use, e.g. on stage, discos, clubs, bars or theatres. It is
applicable for mobile use and permanent installations.
• When operating a laser product in public or industrial
areas, a series of safety instructions have to be
followed that this manual can only give in part. The
operator must therefore inform himself on the current
safety instructions and consider them. The operator is
responsible for compliance with safety measures and
must inform personnel upon the danger of laser
radiation and the required protective measures.
• Always observe the safety regulations of the country
where the unit is operated.
• This device is not designed for permanent operation.
Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
• This product was designed for indoor use only. The
ambient temperature must always be between -5° C
and +45° C. Keep away from direct insulation
(particularly in cars) and heaters. The relative
humidity must not exceed 50 % with an ambient
temperature of 45° C. This device must only be
operated in an altitude between -20 and 2000 m over
NN.
Power Supply
• This product is allowed to be operated with an
alternating current of 100-240 V, 50/60 Hz and was
designed for indoor use only. The occupation of the
connection cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected! If the device will be
directly connected with the local power supply
network, a disconnection switch with a minimum
opening of 3 mm at every pole has to be included in
the permanent electrical installation. The device must
only be connected with an electric installation carried
out in compliance with the IEC standards. The electric
installation must be equipped with a Residual Current
Device (RCD) with a maximum fault current of 30 mA
Installation
• Always set up and install the unit so that a minimum
distance of 1 m is kept between the laser light and the
audience.
• This device is only allowed for overhead installation
via the mounting bracket. In order to safeguard
sufficient ventilation, leave 50 cm of free space
around the device.
• The minimum distance between light output and the
illuminated surface must be more than 0.1 meters.
www.eurolite.de
International
L
N
• Make sure that the area below the installation place is
blocked when rigging, derigging or servicing the
fixture.
• For overhead use, always fix the unit with an
appropriate safety rope.
Operation
• For a safe operation, laser products must be
equipped with all protective measures demanded for
their classification and use.
• Operate the device only after having familiarized with
its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are
the result of unprofessional operation.
• Please consider that unauthorized modifications on
the device are forbidden due to safety reasons. If this
device will be operated in any way different to the one
described in this manual, the product may suffer
damages and the guarantee becomes void.
Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock,
irreversible eye damage etc.
• EUROLITE is not liable for any damages caused by
improper installation and use of this laser.
Serial Code
• Never remove the serial barcode from the device as
this would make the guarantee void.
19