Specifications - Sharp AN-60KT Service Anleitung

PG-M25X

Specifications

Product type
Video system
Display method
DMD panel
Projection lamp
Component input signal
(INPUT1)
Horizontal resolution
Computer RGB input signal
(INPUT 1)
S-video input signal
(INPUT 2)
Video input signal
(INPUT 3)
Pixel clock
Vertical frequency
Horizontal frequency
Audio input signal
PC card slot
Audio output
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Heat dissipation
Operating temperature
Storage temperature
GyroRemote Radio Frequency Range
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
* Temporary noise may be visible with vertical frequencies above 100Hz if OSD functions are activated.
This SHARP projector uses a DMD panel. This very so-
phisticated panel contains 786,432 pixels. As with any high
technology electronic equipment such as large screen TVs,
video systems and video cameras, there are certain ac-
ceptable tolerances that the equipment must conform to.
Digital Multimedia Projector
Model PG-M25X
NTSC 3.58/NTSC 4.43/PAL/PAL-M/PAL-N/PAL 60/SECAM/
DTV480I/DTV480P/DTV720P/DTV1080I
Single Chip Digital Micromirror Device™ (DMD™) by Texas Instruments
Panel size: 0.7" (17.8 mm), 1 chip XGA DMD
No. of dots: 786,432 dots (1,024 [H] × 768 [V])
1–1.2 × zoom lens, F1.75–2.04, f = 28.0–33.5 mm
Lens
High Intensity Discharge Lamp (HID Lamp), DC 210 W
29-pin connector
DVI input signal: Digital 250–1,000 mV 50 Ω
Analog 0.7 Vp-p 75 Ω
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
: 0.7 Vp-p, 75 Ω terminated
P
B
: 0.7 Vp-p, 75 Ω terminated
P
R
700 TV lines (DTV720P)
29-pin connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75 Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
4-pin Mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75 Ω terminated
RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω
terminated
12–230 MHz
43–200 Hz*
15–126 kHz
ø3.5 mm M : AUDIO, 0.5 Vrms, more than 47 kΩ (stereo)
INIJACK
PCMCIA-TYPE II
2.0 W (monaural)
4 cm × 3 cm
AC 100–240 V
3.2 A
50/60 Hz
295 W
XXXX BTU/hour
41°F to 95°F (+5°C to +35°C)
–4°F to 140°F (–20°C to +60°C)
Cabinet Plastic
49.825 – 49.895 MHz (for U.S., Canada etc.), 40.667 – 40.695 MHz (for Europe, Oceania,
Asia)
" × 3" × 11 " (219 (W) × 76 (H) × 303 (D) mm) (main body only)
8 5 ⁄ 15 ⁄
8 16
" × 3 " × 12 " (223 (W) × 83 (H) × 318 (D) mm) (including adjustment feet
8 3 ⁄ 1 ⁄ 1 ⁄
4 4 2
and projecting parts)
5.8 lbs. (2.6 kg)
GyroRemote for U.S., Canada etc., GyroRemote for Europe, Australia, Oceania and Asia, Four
R-03 batteries, Power cord for U.S., Canada etc. (6', 1.8 m), Power cord for Europe, except U.K.
(6', 1.8 m), Power cord for U.K., Hong Kong and Singapore (6', 1.8 m), Power cord for Australia,
New Zealand and Oceania (6', 1.8 m), DVI to 15-pin D-sub cable (6', 1.8 m), USB cable (6', 1.8 m),
Carrying case, Lens cap (attached), Lens cap strap, Terminal cover (attached), CD-ROM, Opera-
tion manual, Quick reference guides, Wireless Reality operation manual, Wireless LAN PC
Card IMPORTANT INFORMATION.
Lamp unit (Lamp/cage module) (BQC-PGM20X//1), GyroRemote for U.S., Canada etc.
(RRMCG1631CESA), GyroRemote for Europe, Australia, Oceania and Asia (RRMCG1653CESA),
Four R-03 batteries ("AAA" size, UM/SUM-4, HP-16, or similar), Power cord for U.S., Canada etc.
(QACCDA007WJPZ), Power cord for Europe, except U.K. (QACCV4002CEZZ), Power cord for
U.K., Hong Kong and Singapore (QACCB5024CENA), Power cord for Australia, New Zealand
and Oceania (QACCL3022CEZZ), DVI to 15-pin D-sub cable (QCNWGA010WJZZ), USB cable
(QCNWG0001WJPZ), Two wireless LAN cards (AN-WC11B), Carrying case (GCASN0005CESA),
Lens cap (CCAPHA001WJ01), Lens cap strap (UBNDT0013CEZZ), Terminal cover
(GCOVD0103CESA), CD-ROM (UDSKA0058CEN1), Operation manual (TINS-A046WJZZ),
Quick reference guides, Wireless LAN PC Card IMPORTANT INFORMATION.
Specifications are subject to change without notice.
This unit has some inactive pixels within acceptable toler-
ances which may result in inactive dots on the picture screen.
This will not affect the picture quality or the life expectancy
of the unit.
2